Kia Carnival (2009+). Manual — part 432

8. Before connecting connectors, make sure the terminals (A) are in place and not bent.

9. Check for loose retainer (A) and rubber seals (B).

10. The backs of some connectors are packed with grease. Add grease if necessary. If the grease (A) is

contaminated, replace it.

11. Insert the connector all the way and make sure it is securely locked.

12. Position wires so that the open end of the cover faces down.

HANDLING WIRES AND HARNESSES

1. Secure wires and wire harnesses to the frame with their respective wire ties at the designated locations.

2. Remove clips carefully; don't damage their locks (A).

3. Slip pliers (A) under the clip base and through the hole at an angle, and then squeeze the expansion tabs to

release the clip.

4. After installing harness clips, make sure the harness doesn't interfere with any moving parts.

5. Keep wire harnesses away from exhaust pipes and other hot parts, from sharp edges of brackets and holes, and

from exposed screws and bolts.

6. Seat grommets in their grooves properly (A). Do not leave grommets distorted (B).

TESTING AND REPAIRS

1. Do not use wires or harnesses with broken insulation.

Replace them or repair them by wrapping the break with electrical tape.

2. After installing parts, make sure that no wires are pinched under them.

3. When using electrical test equipment, follow the manufacturer's instructions and those described in this manual.

4. If possible, insert the probe of the tester from the wire side (except waterproof connector).

5. Use a probe with a tapered tip.

FIVE-STEP TROUBLESHOOTING

1. Verify the complaint

Turn on all the components in the problem circuit to verify the customer complaint. Note the symptoms. Do not
begin disassembly or testing until you have narrowed down the problem area.

2. Analyze the schematic

Look up the schematic for the problem circuit.
Determine how the circuit is supposed to work by tracing the current paths from the power feed through the circuit
components to ground. If several circuits fail at the same time, the fuse or ground is a likely cause.
Based on the symptoms and your understanding of the circuit operation, identify one or more possible causes of
the problem.

3. Isolate the problem by testing the circuit

Make circuit tests to check the diagnosis you made in step 2. Keep in mind that a logical, simple procedure is the
key to efficient troubleshooting.
Test for the most likely cause of failure first. Try to make tests at points that are easily accessible.

4. Fix the problem

Once the specific problem is identified, make the repair. Be sure to use proper tools and safe procedures.

5. Make sure the circuit works

Turn on all components in the repaired circuit in all modes to make sure you've fixed the entire problem. If the
problem was a blown fuse, be sure to test all of the circuits on the fuse. Make sure no new problems turn up and
the original problem does not recur