Kia Carnival (2009+). Manual — part 332

2. Remove ignition key from the vehicle.

3. Connect the clock spring harness connetor and horn harness connector to the clock spring.

4. Set the clock spring on neutral position and after turning the front wheels to the straight-ahead position, install the

clock spring.

As described direction on the clock spring warning label, align the centerline with adjusting the setting
mark(▶

◀) when installing the clock spring.

5. Install the steering wheel column cover and the steering wheel. (Refer to ST group)

6. Connect the Driver Airbag (DAB) module connector and horn connector, then install the Driver Airbag (DAB)

module on the steering wheel.

7. Secure the Driver Airbag (DAB) with the new mounting bolts.

Tightening Torque (DAB Mounting Bolt)
: 0.8 ~ 1.1 kgf.m (7.9 ~ 10.8 Nm, 5.8 ~ 8.0 lb.ft)

8. Connect the battery negative cable.

9. After installing the airbag, confirm proper system operation:

A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
B. Make sure horn button works.

INSPECTION

Driver Airbag (DAB)

If any improper parts are found during the following inspection, replace the airbag module with a new one.

Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious
personal injury.

personal injury.

1. Check pad cover for dents, cracks or deformities.

2. Check the airbag module for denting, cracking or deformation.

3. Check hooks and connectors for damage, terminals for deformities, and harness for binds.

4. Check airbag inflator case for dents, cracks or deformities.

5. Install the airbag module to the steering wheel to check for fit or alignment with the wheel.

Clockspring

1. If, as a result of the following checks, even one abnormal point is discovered, replace the clock spring with a new

one.

2. Check connectors and protective tube for damage, and terminals for deformities.

Restraint

Airbag Module - Passenger Airbag (PAB) Module

Restraint

2009 > G 2.7 DOHC >

DESCRIPTION

The passenger Airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal
crash. The SRSCM determines if and when to deploy the PAB.

Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious
personal injury.