Kia Carnival (2009+). Manual — part 320

9. If there is not continuity between the terminals in the table above for each switch position, replace the inhibiter

switch.

ADJUSTMENT

1. Set the select lever to the "N" position.

2. Loosen the control cable to manual control lever coupling nut to free the cable and lever.

3. Set the manual control lever to the neutral position.

4. Loosen the transaxle range switch body mounting bolts and then turn the transaxle range switch body so the hole

in the end of the manual control lever and the hole (cross section A-A in the figure) in the flange of the transaxle
range switch body flange are aligned.

5. Tighten the transaxle range switch body mounting bolts to the specified torque. Make sure at this time that the

position of the switch body did not move.

TORQUE :
10~12Nm (1.0~1.2kgf.m, 7~8lb-ft)

6. Gently pull the transmission control cable in the direction of the arrow, and then tighten the adjusting nut.

7. Check that the select lever is in the "N" position.

Restraint

General Information

Restraint

2009 > G 2.7 DOHC >

Precautions

General Precautions

Please read the following precautions carefully before performing the airbag system service. Observe the instructions
described in this manual, or the airbags could accidentally deploy and cause damage or injuries.

• Except when performing electrical inspections, always turn the ignition switch OFF and disconnect the negative

cable from the battery, and wait at least three minutes before beginning work.

The contents in the memory are not erased even if the ignition switch is turned OFF or the battery cables are
disconnected from the battery.

• Use the replacement parts which are manufactured to the same standards as the original parts and quality.

Do not install used SRS parts from another vehicle.
Use only new parts when making SRS repairs.

• Carefully inspect any SRS part before you install it.

Do not install any part that shows signs of being dropped or improperly handled, such as dents, cracks or
deformation.

• Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS

connector.

Airbag Handling and Storage

Do not disassemble the airbags; it has no serviceable parts. Once an airbag has been deployed, it cannot be repaired
or reused.
For temporary storage of the air bag during service, please observe the following precautions.

• Store the removed airbag with the pad surface up.
• Keep free from any oil, grease, detergent, or water to prevent damage to the airbag assembly.