Kia Carnival (2009+). Manual — part 131

2. Check that there is no continuity between the slip rings and the rotor (B) or rotor shaft (C).

3. If the rotor fails either continuity check, replace the alternator.

INSPECT STATOR

1. Check that there is continuity between each pair of leads (A).

2. Check that there is no continuity between each lead and the coil core.

3. If the coil fails either continuity check, replace the alternator.

2009 > G 3.8 DOHC >

DESCRIPTION

1. The maintenance-free battery is, as the name implies, totally maintenance free and has no removable battery cell

caps.

2. Water never needs to be added to the maintenance-free battery.

3. The battery is completely sealed, except for small vent holes in the cover.

Engine Electrical System

Charging System - Battery

2009 > G 3.8 DOHC >

INSPECTION

CHECKING PROCEDURE OF BATTERY

CHECKING FLOW

LOAD TEST

1. Perform the following steps to complete the load test procedure for maintenance free batteries.

2. Connect the load tester clamps to the terminals and proceed with the test as follow:

(1) If the battery has been on charge, remove the surface charge by connecting a 300ampere load for 15 seconds.

(2) Connect the voltmeter and apply the specified load.

(3) Read the voltage after the load has been applied for 15 seconds.

(4) Disconnect the load.

(5) Compare the voltage reading with the minimum and replace the battery if battery test voltage is below that

shown in the voltage table.

Voltage

Temperature

9.6V

20°C (68.0°F) and above

9.5V

16°C (60.8°F)

9.4V

10°C (50.0°F)

9.3V

4°C (39.2°F)

9.1V

-1°C (30.2°F)

8.9V

-7°C (19.4°F)

8.7V

-12°C (10.4°F)

8.5V

-18°C (-0.4°F)

- If the voltage is greater than shown in the table, the battery is good.
- If the voltage is less than shown in the table, replace the battery.

BATTERY DIAGNOSTIC TEST (2)

1. Make sure the ignition switch and all accessories are in the OFF position.

2. Disconnect the battery cables (negative first).

3. Remove the battery from the vehicle.

Care should be taken in the event the battery case is cracked or leaking, to protect your skin from the
electrolyte.
Heavy rubber gloves (not the household type) should be wore when removing the battery.

4. Inspect the battery tray for damage caused by the loss of electrolyte. If acid damage is present, it will be necessary

to clean the area with a solution of clean warm water and baking soda. Scrub the area with a stiff brush and wipe
off with a cloth moistened with baking soda and water.

5. Clean the top of the battery with the same solution as described above.

6. Inspect the battery case and cover for cracks. If cracks are present, the battery must be replaced.

7. Clean the battery posts with a suitable battery post tool.

8. Clean the inside surface of the terminal clamps with a suitable battery cleaning tool. Replace damaged or frayed

cables and broken terminal clamps.

9. Install the battery in the vehicle.

10. Connect the cable terminals to the battery post, making sure tops of the terminals are flush with the tops of the

posts.

11. Tighten the terminal nuts securely.

12. Coat all connections with light mineral grease after tightening.