Kia Carnival (2009+). Manual — part 226

4. Disconnect the battery also from the body. If the pinion retracts immediately, it is working properly. To avoid

damaging the starter, do not leave the battery connected for more than 10 seconds.

FREE RUNNING TEST

1. Place the starter motor in a vise equipped with soft jaws and connect a fully-charged 12-volt battery to starter

motor as follows.

2. Connect a test ammeter (100-ampere scale) and carbon pile rheostats shown is the illustration.

3. Connect a voltmeter (15-volt scale) across starter motor.

4. Rotate carbon pile to the off position.

5. Connect the battery cable from battery's negative post to the starter motor body.

6. Adjust until battery voltage shown on the voltmeter reads 11volts.

7. Confirm that the maximum amperage is within the specifications and that the starter motor turns smoothly and

freely.

Current : 900A
Speed : 2,800 rpm

Engine Electrical System

Starting System - Starter

Engine ,SLJ[YPcal System

2009 > G 2.7 DOHC >

COMPONENT

2009 > G 2.7 DOHC >

REMOVAL

STATATER

1. Disconnect the battery negative cable.

2. Disconnect the starter cable (A) from the B terminal (B) on the solenoid (C), then disconnect the connector (D)

from the S terminal (E).

3. Remove the 2 bolts holding the starter, then remove the starter.

4. Installation is the reverse of removal.

5. Connect the battery negative cable to the battery.

DISASSEMBLY

1. Disconnect the M-terminal (A) on the magnet switch assembly (B).

2. After loosening the 3 screws (A), detach the magnet switch assembly (B).

3. Loosen the through bolts (A).

4. Remove the brush holder assembly (A), yoke (b) and armature (C).