Kia Carnival (2009+). Manual — part 127
Engine Electrical System
Ignition System
DESCRITION
Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data
for the engine operating conditions are preprogrammed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on
these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM. The
ignition coil is activated, and timing is controlled.
2009 > G 3.8 DOHC >
REMOVAL
IGNITION COIL
1. Remove the engine cover.
2. Disconnect the ignition coil connector(A).
When removing the ignition coil connector, pull the lock pin(A) and push the clip(B).
3. Remove the ignition coil (B).
4. Installation is the reverse of removal.
ON-VEHICLE INSPECTION
SPARK TEST
1. Remove the ignition coil connector(A).
When removing the ignition coil connector, pull the lock pin (A) and push the clip(B).
2. Remove bolt holding down the ignition coil.
3. Remove ignition coil from engine.
4. Using a spark plug socket, remove the spark plug.
5. Attach the spark plug to the ignition coil.
6. Reconnect ignition coil harness connector to ignition coil.
7. Ground the spark plug to the engine.
8. Check if spark occurs while engine is being cranked.
To prevent fuel being injected from injectors while the engine is being cranked, remove the fuel pump relay(A)
from the fuse box.
Crank the engine for no more than 5 ~ 10 seconds.
9. Continue to inspect other cylinders of suspected 'no spark' concerns.
10. Install in the reverse order of testing and removal.
INSPECT SPARK PLUG
1. Remove the ignition coil connector(A).
When removing the ignition coil connector, pull the lock pin(A) and push the clip(B).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст