Kia Carnival (2009+). Manual — part 472

Tolerance

(rpm)

5,000

6,000

7,000

8,000

Engine

Revolution

(rpm)

±150

±180

±210

-

Gasoline

±150

±150

-

-

Diesel

FUEL GAUGE SENDER

1. Using an ohmmeter, measure the resistance between terminals 1 and 2 of sender connector (A) at each float level.

2. Also check that the resistance changes smoothly when the float is moved from "E" to "F".

Position

Resistance(!)

Sender (E)

200

Warning lamp

160

1/2

54.5

Sender (F)

8

If the height resistance is not within specifications, replace the fuel sender as an assembly.
After completing this test, wipe the sender dry and reinstall it in the fuel tank.

ENGINE COOLANT TEMPERATURE SENDER

1. Using an ohmmeter, measure the resistance between the terminal 2 and ground.

Temperature

[°F(°C)]

140

(60)

185

(85)

230

(110)

257

(127.4)

E/G

Resistance (!)

128

56.1

25.2

16.1

Gasoline

Temperature

[°F(°C)]

120

(49)

160

(71)

230

(110)

260

(127.4)

E/G

Resistance (!)

209.6

88.7

24.3

15.9

Diesel

OIL PRESSURE SWITCH

1. Check that there is continuity between the oil press switch terminal and ground with the engine off.

2. Check that there is no continuity between the terminal and ground with the engine running.

3. If operation is not as specified, replace the switch.

4. Connect the oil pressure switch wire harness.

5. Turn the ignition switch ON. Check that the warning lamp lights up. If the warning lamp doesn't light, test the wire

harness.

BRAKE FLUID LEVEL WARNING SWITCH

1. Remove the connector (A) from the switch located at the brake fluid reservoir (B).

2. Verify that continuity exists between switch terminals 1 and 2 while pressing the switch (float) down with a rod.

BRAKE FLUID LEVEL WARNING LAMP

1. Ignition "ON"

2. Release the parking brake.

3. Remove the connector from the brake fluid level warning switch.

4. Ground the connector at the harness side.

5. Verify that the warning lamp lights.

PARKING BRAKE SWITCH

The parking brake switch is a push type. It is located at the side of the parking brake pedal.

1. Check that there is continuity between the terminal and switch body with the switch (A) ON.

2. Check that there is no continuity between the terminal and switch body with the switch OFF.

If continuity is not as specified, replace the switch or inspect its ground connection.

DOOR SWITCH

Remove the door switch and check for continuity between the terminals. If continuity is not as specified, replace the
door switch.

SEAT BELT SWITCH

1. Remove the connector from the switch.

2. Check for continuity between terminals.

Seat belt condition

Continuity

Fastened

Non-conductive (" !)

Not fastened

Conductive (0 !)

SEAT BELT WARNING LAMP

With the ignition switch turned ON, verify that the lamp glows.

Seat belt condition

Warning lamp

Fastened

OFF

Not fastened

ON