Kia Carnival (2009+). Manual — part 435

2009 > G 2.7 DOHC >

Inspection

Troubleshooting for RSE system and audion unit

Problem

Possible causes / Solution

The disc becomes stuck or blocked.

1. Press the Stop / Eject button to release the disc.
2. The player will attempt to eject the disc up to three times

performing the Auto-Reload function.

3. Once the Auto-Reload function is complete, press the Stop/Ejuct

button again to release the disc from the player.

4. If a disc is still stuck or blocked in the RSE unit, turn the ignition

off and then on again to reset the RSE unit.

There is no audio in the headphones.

1. Verify that the headphone is equipped with batteries, and that the

batteries are changed.

2. Insert or replace 2 AAA batteries to resume headphone function.

The RSE does not work.

1. Press the PLAY button. If the display does not show "NO DISC",

then there is no power.

2. Check the power connection and the fuse.
3. Turn the vehicle ignition off and back on to reset the RSE.

The remote control does not work.

1. Make sure you are pointing the remote control at the face of the

RSE at a 45° angle.

2. Change the battery. [Device requires one(1) CR2025 battery.]
3. Use the control buttons on the RSE display panel.

Continue receiving an [!] when a button is
pressed.

Invalid button press. The function you are trying to perform is not
available.

RSE has no sound, display, illumination at all.

- If ,when connected to power supplier, RSE unit works well, check

the connector.

Spring in the latch is missed.

- Re-assemble spring with latch.

Mechanism cannot read the disc.

- Check if the disc has some scratches or pits.
- In case the disc is stuck, after doing power off reset by pulling

both audio fuses, wait 5 minutes an reinsert the fuses with key
off. After turning on the ignition, press the eject key again.

Audio is not interfaced with RSE.

- Check the connection between Audio and RSE through

multimeter.

- And measure the keydata line of the RSE and verify that 5 volts

is coming out.

Replacement

1. Disconnect the negative (-) battery terminal.

2. Remove the center facia panel, console lower cover, center air vent, switches, tray and heater control panel (A).

(Refer to the Body group-Crash pad)

3. Remove the mounting 4 screws then remove the audio unit (A).

4. Installation is the reverse of removal.

Video Jack (DVD Only)

1. Disconnect the negative (-) battery terminal.

2. Remove the video jack cover (A). And then remove the video jack (B).

3. Installation is the reverse of removal.

Removal Seat Entertainment (DVD Only)

1. Disconnect the negative (-) battery terminal.

2. Remove the DVD rear monitor cover (A) and disconnect the interior lamp connector.

3. Remove the DVD rear monitor (A) mounting bolts (4EA) and disconnect the DVD rear monitor connector.

Installation

1. Tighten the 4 bolts.

2. Connect the lamp connector.

3. Insert the rear part of console to RSE unit.

4. Match the front part of console not to fall the rear part down.

5. Holding the front panel up, matching the ribs.

6. Push the middle part of console by too much force.

Body Electrical System

Audio - Speakers

Body Electrical System