Kia Carnival (2009+). Manual — part 405

4. Installation is the reverse of removal.

DOOR ACTUATOR REPLACEMENT

1. Remove the inside handle.

2. Remove the door trim.

3. Remove the door trim seal.

4. Disconnect the connector (A) and cable (B).

5. After loosening the mounting bolts and nuts, then remove the actuator assembly (A).

6. Disconnect the outside handle cable (A).

7. Installation is the reverse of removal.

DOOR BELT WEATHERSTRIP REPLACEMENT

1. Loosen the mounting screw, then remove the door belt weather strip (A).

2. Installation is the reverse of removal.

DOOR MOTOR REPLACEMENT

1. Remove the rear combination ramp.

2. After loosening the rail cover mounting bolts, then remove the rail cover (A).

3. Remove the rear cable (A).

4. Loosen the mounting bolts, remove the bracket (A).

5. Remove the front cable (B).

6. Disconnect the connector.

7. After removing the motor mounting and nut, remove the motor (A).

8. Installation is the reverse of removal.

ADJUSTMENT

GLASS ADJUSTMENT

- Check the glass run channel for damage or deterioration, and replace them necessary.

1. Remove the following parts.

A. Door trim.

2. Carefully move the glass (A) until you can see the glass mounting bolts then loosen them.

3. Push the glass against the channel then tighten the glass mounting bolts.

4. Check that the glass moves smoothly.

5. Raise the glass fully, and check for gaps. check that the glass contacts the glass run channel evenly.

6. Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:

A. Use a 12mm (1/2in.) diameter hose (A).
B. Adjust the rate of water flow as shown (B).
C. Do not use a nozzle.
D. Hold the hose about 300mm(12in.) away from The door.