Kia Carnival (2009+). Manual — part 449
B. When the multifunction switch is not in postion headlamps turned on or autolight
C. 20 mn after the driver door is open
D. 20mn after IGN leaves the positions RUN to ACC or OFF
E. If IPM receives RKE "LOCK" command two times
3. Escort function enables only "Head Lamp Low Beam", so Park/Tail lamp should be turned off when driver door is
opened at key out (Battery Saver function).
4. Functional Diagram
Interior Lighting Functions
Room Lamps
1. The room lamps are can be controlled manually using the 3-state (ON, DOOR, OFF) switch or by the Rear Area
Module (RAM). A main switch, located to the left of the steering wheel, is used as a master control switch. The
operating logic of the lamps will vary based on the position of the main switch ON, DOOR, or OFF).
2. Working conditions
A. The functioning depends on the key position in the key cylinder (OFF, ACC, RUN or START)
B. When the key goes in RUN or START position while the room lamps are decaying, then the room lamps are
turned off immediately.
C. When the Ignition key position is RUN or START and the last door is closed then the room lamps are OFF.
D. If the room lamps have been activated using the RKE UNLOCK function, and the ignition switch is turned to the
RUN or START position, the room lamps will be immediately turned OFF..
E. If the Ignition sw status is in RUN or START and Unlock information occurs, then the room lamp status is not
changed.
F. When the system enters to ARM WAIT mode by Remote Key or Mechanical cylinder lock switches the Room
lamp should be turned off immediately.
G. If there is RKE Lock signal at any door open, all doors should be locked first and wait for the all door close. No
action is taken while the Open Door status is OPEN and the doors are locked. Then when Open Door status
changes from OPEN to CLOSE, Room lamps will be OFF immediately.
H. The 30sec timer does not depend on the key reminder status.
I. If the main switch is changed to ON from DOOR after 20minute lamp OFF, all the lamps are turned ON.
J. If the Open Door status changes from OPEN to CLOSE (all doors close) when ignition switch is on RUN
position, room lamps and door courtesy lamps should turn off immediately (Do not decay off).
K. After 20minute Room Lamp OFF at door open, Room lamps are turned ON again when:
• One of the door open switch's status changes. (Open to Close or Close to Open)
• Ignition key is in RUN or START Position.
• Receiving an UNLOCK event while a door is open and Main Room Lamp Switch is in the DOOR position.
L. For the room lamps, when the 20m timer is running and any of the side doors is opened the timer is restarted.
3. Functional Diagram
4. Truth table
Main Room
Lamp sw
Open Door
status (RAM)
Luggage
interior Lamp
(CAN)
Room
Lamps LS
(Door)
Room
Lamps LS
(On)
Room Lamp
Switch
Room Lamp
Switch
Room Lamp
Switch
ON
DOOR
OFF
OFF
Don't care
Don't care
OFF
OFF
OFF
OFF
OFF
ON
Don't care
Don't care
OFF
ON
ON
ON
ON
DOOR
OPEN
OFF
(*)
ON during
20 min then
directly OFF
OFF
ON
ON during
20 min
OFF
OPEN
!LOCK
(**)
ON during
20 min then
directly OFF
OFF
ON during
20 min
OPEN
!UNLOCK
(***)
ON during
20 min then
directly OFF
OFF
ON during
20 min
CLOSE
OFF
OFF
OFF
OFF
OPEN !
CLOSE
Don't care
Decayed
OFF
OFF
Decayed
OFF
OPEN !
CLOSE
Don't care
ON during
20 min then
directly OFF
OFF
ON during
20 min
CLOSE
!LOCK
OFF
OFF
OFF
CLOSE
!UNLOCK
ON during
30 min then
directly OFF
OFF
ON during
30 min
(*) : OFF is transmitted when there is no action from Lock/Unlock. It has no impact on the 20mn timer (no restart).
(**) : LOCK transition is sent by IPM only when door status is CLOSE. Thus there is no action on the 20mn timer in
this case.
(***) : When transition to UNLOCK is received, 20mn timer is restarted.
Map Lamp
1. The map lamps may be controlled manually or by the Rear Area Module (RAM).
2. Functional Diagram
3. Truth table
Main Room Lamp
sw
Open Door status
(RAM)
Luggage interior
Lamp (CAN)
Map Lamp LS
Map Lamp Switch Map Lamp Switch
ON
OFF
OFF
Don't care
Don't care
OFF
ON
OFF
ON
Don't care
Don't care
ON
ON
ON
DOOR
OPEN
OFF
(*)
ON during 20 min
then directly OFF
ON
ON during 20 min
OPEN
! LOCK
(**)
ON during 20 min
then directly OFF
ON
ON during 20 min
OPEN
! UNLOCK
(***)
ON during 20 min
then directly OFF
ON
ON during 20 min
CLOSE
OFF
OFF
ON
OFF
CLOSE
! LOCK
OFF
ON
OFF
CLOSE
!UNLOCK
ON during 30 min
then directly OFF
ON
ON during 30 min
OPEN ! CLOSE
Don't care
OFf (DECAY)
ON
OFf (DECAY)
CLOSE ! OPEN
Don't care
ON during 20 min
then directly OFF
ON
ON during 20 min
(*) : OFF is transmitted when there is no action from Lock/Unlock. It has no impact on the 20mn timer (no restart).
(**) : LOCK transition is sent by IPM only when door status is CLOSE. Thus there is no action on the 20mn timer in
this case.
(***) : When transition to UNLOCK is received, 20mn timer is restarted.
Luggage Lamp
1. Working Conditions
A. The 20min timer does not depend on the key reminder status.
B. After 20minute Luggage Lamp OFF at tailgate open, luggage lamps are turned ON again when:
• Tailgate close and then tailgate is opened again
• Ignition key is in RUN or START position.
2. Truth table
Main Room Lamp sw
Tail Gate status
(RAM)
Luggage Lamp LS
Luggage Lamp
Switch
Luggage Lamp
Switch
DOOR
OFF
OFF
OPEN
ON
ON
OFF
CLOSE
OFF
OFF
OFF
ON
Don't care
OFF
ON
ON
DOOR
OPEN
ON during 20 min
then directly OFF
ON during 20 min
OFF
CLOSE
OFF
OFF
OPEN ! CLOSE
OFF
OFF
CLOSE ! OPEN
ON during 20 min
then directly OFF
ON during 20 min
Door Courtesy Lamps
Key Hole Illumination
1. Working Conditions
The key cylinder is illuminated when the driver and / or the assist door are open.
2. Key hole extinguish conditions:
A. The key cylinder is turned off 10s after the driver and assist doors are closed.
B. The key cylinder is turned off immediately if the key is inserted in the hole and put to RUN or START position.
C. For vehicles equipped with BurglarAlarm, the key cylinder is turned off immediately when the system goes to
ARM WAIT mode during the 10s after the driver and assist doors are closed.
D. For vehicles not equipped with BurglarAlarm, the key cylinder is turned off immediately when RKE lock signal is
received from keyfob during the 10s after the driver and assist doors are closed (4).
3. Functional Diagram
Panel Lights, Switch Illumination
1. Working Conditions
The MF "high beam" and "flash to pass" switches do not influence the management of the Panel Lights and Trip
Computer illumination, Rear Blower illumination and Rear Monitor illumination.
2. Functional Diagram
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст