Suzuki Grand Vitara JB416 / JB420 / JB419. Manual — part 487
![](/vehicles/jari/lstist/oryont/riny.png)
9B-33 Lighting Systems:
Auto-On Headlight Sensor Inspection (If
Equipped)
S6JB0A9206030
1) Disconnect negative (–) cable at battery.
2) Remove auto-on headlight sensor (1) located on the
passenger side of the dashboard (2). Be careful not
to damage the sensor (1) and dashboard by using
rag (3).
3) Measure voltage between white wire terminal and
black wire terminal at the following condition.
If measured voltage is out of specification, replace
sensor.
Auto-on headlight sensor voltage specifications
Cover the sensor lens with hand: 0.4 V
Light the sensor lens with incandescent lamp
100 W: 3 – 4.5 V
Specifications
Tightening Torque Specifications
S6JB0A9207001
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fastener Information in Section 0A”.
2
1
3
I5JB0A920038-01
I5JB0A920039-01
Fastening part
Tightening torque
Note
N
⋅m
kgf-m
lb-ft
Height sensor bolt
10
1.0
7.5
Height sensor nut
10
1.0
7.5
![](/vehicles/jari/lstist/oryont/swher.png)
Instrumentation / Driver Info. / Horn: 9C-1
Body, Cab and Accessories
Instrumentation / Driver Info. / Horn
Precautions
Precautions in Diagnosing Troubles for Combination Meter
S6JB0A9300001
Combination meter uses signals (information) from each control module by CAN communication to control
speedometer, tachometer, fuel meter (petrol engine model), engine coolant temp meter, warning light and indicator
light (other than air bag warning light, headlight leveling warning light, rear fog light and turn signal indicator light).
Therefore, check that no DTC is detected in each module before performing combination meter symptom diagnosis. If
any DTC is detected, correct trouble indicated by that DTC troubleshooting first.
General Description
CAN Communication System Description
S6JB0A9301001
Refer to “CAN Communication System Description: For Petrol Engine Model in Section 1A” or “CAN Communication
System Description: For Diesel Engine Model in Section 1A” for CAN communication system description. Combination
meter communicates control data with each control module as follows.
Combination Meter Transmission Data
BCM
Combination
Meter
DATA
Transmit
Fuel level percent signal
I7RW01930001-01
![](/vehicles/jari/lstist/oryont/neplan.png)
9C-2 Instrumentation / Driver Info. / Horn:
Combination Meter Reception Data
NOTE
*1: Petrol engine model
*2: Diesel engine model
*3: ESP
® model
ECM
BCM
Keyless
Start
Control
Module
(if equipped)
DATA
Recive
Combination
Meter
4WD
Control
Module
(if equipped)
TCM
(A/T
model)
Engine speed signal
Immobilizer indicator light control
signal
Vehicle speed signal
Engine coolant temperature signal
Fuel level signal
MIL control signal
Transmission range sensor signal
Diagnostic trouble code (DTC)
Brake fluid level switch signal
(brake warning light control signal)
Driver side seat belt buckle switch
signal (seat belt reminder light control
signal)
Charging system warning light signal
(charge warning light control signal)
Engine oil pressure switch signal
(oil pressure warning light control
signal)
Parking brake switch signal
(brake warning light control signal)
Lighting switch signal
Door switch signal
(open door warning light control signal)
ABS indication signal
EBD indication signal
(brake warning light control signal)
4WD mode indicator control signal
Key indicator light control signal
ESP status signal
ABS/ESP
Control
Module
"CRUSE" and "SET" indicator light
control signal
Automatic transmission mode indicator
light control signal
Electric load signal
Transmission warning light control
signal
Diesel particulate filter warning light
control signal
Injection waning light control signal
Red stop warning light control signal
Glow ingicator light control signal
Fuel filter warning light control signal
*1
*1
*2
*2
*2
*2
*2
*3
I6JB0A930002-02
![](/vehicles/jari/lstist/oryont/iof.png)
Instrumentation / Driver Info. / Horn: 9C-3
Auto Volume Control System Description (If Equipped)
S6JB0A9301002
Function of auto volume control system is to vary sound volume according to changes of vehicle speed. How much
sound volume varies depends on selected level.
Reference Correlation Chart of Vehicle Speed and Sound Volume
[A]: Vehicle speed
[C]: Acceleration
[E]: Increase
[B]: Sound volume
[D]: Deceleration
[F]: Decrease
[A]
[E]
[F]
[B]
[E]
[F]
[C]
[D]
I6RS0B930004-01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст