JAC Trucks. Manual — part 28
Use of instruments and ap鄄
paratus in the cab
Integrated switch and instru鄄
ment cluster
Integrated switch
(figure below),
which is composed of steering shaft
lock seat尧ignition start lock and
combination switch lies underneath
the steering wheel.
Ignition switch
Ignition switch is on the right side of
integrated switch. It has four func鄄
tions: LOCK尧ACC尧ON尧START. When
the key is on the 'LOCK' position,
the ignition switch has been connect鄄
ed to the power source and lockup
of the steering gear has been disen鄄
gaged. Turn the key to 'ACC' posi鄄
tion clockwise, and circuit of acces鄄
sories like radio and tape player is
connected. Turn the key to "ON' po鄄
sition, and the instrument circuit is
connected. If keep on turning the key
to 'START' position, engine can be
started. You should unlash handle of
the key immediately after the engine
starts. The key can return to "ON'
position by the action of spring.
Combination switch (left control han鄄
dle)
Combination switch is under the
control of the multifunctional handle,
which lies in the lower left and inferi鄄
or place of the steering wheel. It can
control small light尧headlight尧head鄄
light dimmer and left turning or right
turning by two different motion
modes. The symbols and functions of
integrated switch
Ignition switch
2
Ignition switch
Integrated switch
OWNER爷S MANUAL for
HFC1061,HFC1063,HFC1083
series trucks
the combination switch are as fol鄄
lows:
荫
"OFF" indicates that neither small
light nor headlight lights.
荫
is the indication of small
light. Turn the control handle clock鄄
wise by 30o to lighten the front尧rear
small lights and the instrument light .
荫
is the indication of head鄄
light. Keep on turning the left control
handle clockwise by 30oto lighten
the front headlight尧the rear small
light and the instrument light .
荫
is the indication of steering.
Forward and backward motion of the
control handle can operate the left
and the right turning lights and the
turning light indicator on the instru鄄
ment panel. Push the control handle
forward in horizontal direction, the
right turning light lights and there is
indication of turning right on the in鄄
strument panel. On the other hand,
pull the control handle backwards,
the left turning light lights and there
is indication of turning left on the in鄄
strument panel. If the control handle
is in the middle position, there will be
no indication of turning.
荫
Dimmer of headlight: Lift the left
control handle upwards gently and
do the "uplift-release" motion, which
can control the dimmer function of
the headlight. If uplifting the handle
once, high beam headlight lights; if
releasing the handle, it goes out. Re鄄
peating of the above action can con鄄
trol the working condition of the high
beam headlight to achieve the pur鄄
pose of dimmer function when over鄄
taking at night.
Combination switch (right control
handle)
荫
is the indication of syringe.
When the washer control button on
the top of the control handle is
pressed, cleaning mixture (antifreeze
should be used in winter) in the win鄄
dow washer which lies in the right
doorframe and underneath instru鄄
right control handle
left control handle
3
ment panel can be spouted to the
windshield glass through the spout
under the window.
荫
is the indication of wiper.
Turning the control handle clockwise
in horizontal direction can control the
wiper. Turn the control handle clock鄄
wise by 12o to the 'LO' position, the
wiper works at a low speed. Keep on
turning clockwise by another 12o, the
wiper can work at a high speed.
When the control handle is on the o鄄
riginal position, the wiper will be dis鄄
connected or return automatically.
荫
is the indication of exhaust
throttle assistant braking. Lift the
right control handle upward and do
the 'uplift-release' motion. Uplift the
handle, the switch can be connected
and the indicator light on the instru鄄
ment panel lights which shows that
exhaust throttle assistant braking
works. If the accelerator pedal or the
clutch pedal is depressed, the ex鄄
haust assistant braking will be can鄄
celled automatically and the indicator
light on the instrument panel goes
out.
Other electric appliance switches
Other electric appliance switches
mainly include horn button, danger
warning switch, fog lamp switch and
gating ceiling light switch.
1. Horn button is in the center of the
steering wheel. When the button is
pressed, it can hoot.
2.
is the indication of danger
warning switch. If the button is
pressed, the front尧 rear尧 left尧 right
turning lights flash at the same time
and send out emergency signal for
alarm indication. If pressed again,
reset signal of the switch is discon鄄
nected.
3.
is the indication of the fog
light. Press this button, the fog light
lights. Press it again, the switch re鄄
sets.
4. Ceiling light signal indicates
whether the door of the vehicle is
shut closely or not. If one door keeps
open or not shut closely, the ceiling
light will light to remind the driver.
4
OWNER爷S MANUAL for
HFC1061,HFC1063,HFC1083
series trucks
5
Danger alarm and fog lamp switch
Other electric appliance switch
Instrument cluster
New pattern of instrument cluster (air brake)
Indicator lamp
Water temper鄄
ature gauge
fuel gauge
Air pressure
gauge
Mileometer
Speedometer
Tripmeter
Old pattern of instrument cluster (air brake)
Mileometer
Speedometer
Fuel gauge
Indicator lamp
Button for returning to zero
Water temperature gauge
Tripmeter
Air pressure gauge
6
OWNER爷S MANUAL for
HFC1061,HFC1063,HFC1083
series trucks
New pattern of instrument cluster (hydraulic brake)
Old pattern of instrument cluster(hydraulic brake)
Speedometer
Fuel gauge
Indicator lamp
Mileometer
Button for returning to zero
Tripmeter
Water temperature gauge
Electrical clock
7
Indicators :
1. Turning indication light (
)
when the turning control handle is on
the left (right) turning position, left
(right) turning indicator light will flash.
If the warning switch is pressed, the
left and right turning indication light
will flash at the same time.
2. High beam indication light (
)
indicates that whether the headlight
is under the working condition of
high beam . When the headlight is
on the high beam status, the
indicator light will light.
3. Fuel warning lamp (
):used for
fuel level alarm, when fuel is in
shortage, fuel alarm light will light.
4. Parking brake indicator light渊
冤院
when pulling up the parking brake
handle, the indicator light will light.
5. Generator indicator light渊
冤院in
dicates the working condition of
generator. When the battery is
discharged, the indicator light will light;
otherwise, the indicator light will go out.
6.Oil pressure indicator light渊
冤院
indicates low - pressure warning of
engine oil pressure. When oil
pressure is lower than 0.08-0.1Mpa ,
the oil pressure indicator light will
light. When oil pressure is higher
than it, the oil pressure indicator light
will go out.
7. Braking fault indicator light渊
冤院
when braking fluid is not enough, the
indicator light will light..
8. Exhaust assistant brake indicator
1. turn left
2. high beam
3. tur right
4. fuel alarm
5.parking brake
6.charging
7. oil pressure alarm
8.braking fault
9.exhaust assistant brake
10.fog lamp
11.small light
8
Integrated cluster
OWNER爷S MANUAL for
HFC1061,HFC1063,HFC1083
series trucks
light 渊
冤院when exhaust assistant
braking operates, the indicator light
will light. When exhaust assistant
brake is disconnected, the indicator
light will go out.
9. Fog light indication light 渊
冤院
press the switch to make it work.
10. Small light indicati0n light渊
冤院
When they work袁the indication light
will light.
Use of components in the
cab
Cab
Brief description of the structure:
The driver cab is constructed
enclosing with full metal. Window
glass adopts panoramic camber
windshield. In order to improve the
comfort, side panel with larger
upside width and raised -roof cab
have been adopted. Therefore, the
interior space of the cab can be
more commodious and comfortable.
Effective measures have taken in
reducing noise尧 heat insulation尧
sound insulation and sealing. For
instance, the section of roof forehead
is enclosed and strengthening rib is
equipped on the roof. There are
three
asbestos
heat
insulating
mattress on the upside of the engine.
Sealing of the door is double skin
constructed. For safety, softening
has done for the main parts, which
can appear knocking easily with
passengers.
Air -conditioner system (choose
to pack)
Brief introduction
The automobile air -conditioner with
cold and warm machine is integrated
with automobile cluster panel. It has
many useful functions. For example,
to make cold air, warm air and to
remove frost. The air -conditioner
system has four high and low
grades, which meets your need of
9
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст