BMW 3 (E46). Manual — part 9
and Inspection II requirements are
approximately equivalent to the
maintenance requirements that other
European manufacturers specify.
Inspection I is normally due at intervals
with a maximum of 30,000 miles or 24
months. Inspection II is normally due at
intervals with a maximum of 60,000
miles or 48 months.
Maintenance Tables
The intervals for most tasks listed in the maintenance table below are determined by the SII.
Except where noted, the maintenance items listed apply to all models and model years covered
by this manual. The columns on the right side of each table give quick-reference information
about the job. The text in the "additional repair information" column refers to repair groups.
Table a. Oil service
Maintenance item
Tools
required
New parts
required
Warm
engine
required
Dealer service
recommended
Additional
repair
information
Engine compartment
maintenance
Change oil and oil filter
020
Reset Service Interval
Indicator (SII).
020
Replace interior
ventilation microfilter.
020
Under car
maintenance
Check overall thickness
of front and rear brake
pads. If replacement is
necessary: Examine
brake disc surfaces.
Clean brake pad
contact points in
calipers. Grease wheel
centering hubs (alloy
wheels only). Check
thickness of parking
brake linings only when
replacing rear brake
pads. Check operation
of parking brake and
adjust as necessary.
340
Check and adjust tire
pressures, including
spare
020
Table b. Inspection I service
Maintenance item
Tools
required
New parts
required
Warm
engine
required
Dealer service
recommended
Additional
repair
information
Under car
maintenance
Change engine oil and
filter.
020
Check transmission and
differential(s) for
external leaks.
230
240
Check CV joint boots for
damage or leaks.
311
331
Visually check fuel tank,
fuel lines and
connections for leaks.
160
Check condition,
position, and mounting
of exhaust system.
Visually check for leaks.
180
Check power steering
system for leaks. Check
power steering fluid
level and adjust if
necessary.
320
Check steering rack and
tie rods for tightness.
Check condition of front
axle joints, steering
linkage and steering
shaft joints.
320
Check overall thickness
of front and rear brake
pads using special
BMW tool. If
replacement is
necessary: Examine
brake disc surfaces.
Clean brake pad
contact points in
calipers. Grease wheel
340
Table b. Inspection I service
Maintenance item
Tools
required
New parts
required
Warm
engine
required
Dealer service
recommended
Additional
repair
information
centering hubs (alloy
wheels only). Check
thickness of parking
brake linings only when
replacing rear brake
pads. Check operation
of parking brake and
adjust as necessary.
Check front control arm
bushings for damage or
wear.
310
Check brake system
connections and lines
for leaks, damage and
incorrect positioning.
340
Check parking brake
actuator. Adjust if
necessary.
340
Check all tire pressures
(including spare) and
correct if necessary.
Check condition of tires
(outer tread surfaces),
tread wear pattern; in
case of uneven tread
wear, perform a wheel
alignment if requested.
020
Inspect entire body
according to terms of
rust perforation limited
warranty. (Must be
performed at least every
two years.)
Engine compartment
maintenance
Read out on-board
diagnostic (OBD II)
system.
100
130
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст