BMW 3 (E46). Manual — part 203
-
Remove front door panel as
described in
411 Doors
.
-
Disconnect negative (-) cable from
battery. Then remove airbag unit
and vapor barrier from door. See
721 Airbag System (SRS)
.
WARNING!
Prior to disconnecting the battery,
read the battery disconnection
cautions given at the front of this
manual on page viii.
Detach window from window regulator
rails:
Reattach battery. Move window to
approx. 140 mm (5.5 in.) from
bottom.
Remove window retaining screws
(insets) at window regulator rails.
WARNING!
Once the window is positioned
correctly, disconnect harness
connector from power window motor
to prevent accidental operation of
the window.
Detach plastic window retainers from
glass:
Push expander nut (1) out of
plastic retainer.
Squeeze retainer tabs (2) and
remove from glass.
Note:
BMW recommends replacing the plastic
window retainers every time the glass is
removed from the door.
Turn window glass carefully inside door
cavity and lift out of door.
-
Installation is reverse of removal.
Replace plastic window retainers
once glass is inside door.
Use new mounting bolts when
reinstalling side-impact airbag to
door.
Adjust window as described
earlier.
Tightening torque
Side-impact airbag
to door
8.5 Nm (75
in-lb)
Window to
regulator guide
8 Nm (71 in-lb)
Rear door window, removing
and installing (4-door models)
-
Remove rear door panel and vapor
barrier. See
411 Doors
.
-
In model with rear side impact
airbag: Disconnect negative (-)
cable from battery. Then remove
airbag unit from door. See
721
Airbag System (SRS)
.
Detach window from window regulator
rail:
If applicable, reattach battery.
Move window to approx. 115 mm
(4.5 in.) from bottom.
Remove window retaining screw
(inset) at window regulator rail.
WARNING!
Once the window is positioned
correctly, disconnect harness
connector from power window motor
to prevent accidental operation of
the window.
Detach plastic window retainer from
glass:
Push expander nut (1) out of
plastic retainer.
Squeeze retainer tabs (2) and
remove from glass.
Note:
BMW recommends replacing the plastic
window retainer every time the glass is
removed from the door.
-
Pull window glass straight up to
lift out of door.
-
Installation is reverse of removal.
Replace plastic window retainer
once glass is inside door.
If applicable, use new mounting
bolts when reinstalling side-impact
airbag to door.
Rear window does not need
adjustment.
Tightening torque
Side-impact airbag
to door
8.5 Nm (75
in-lb)
Window to
regulator guide
8 Nm (71 in-lb)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст