Hummer H3. Manual — part 908
REAR SIDE DOOR CHECK LINK REPLACEMENT
Fig. 19: Rear Door Check Link Replacement
Courtesy of GENERAL MOTORS CORP.
Rear Side Door Check Link Replacement
1. Remove the interior trim panel. Refer to Front Side Door Trim Panel
Replacement .
2. Remove the water deflector. Refer to Front Side Door Water Deflector
Replacement .
3. Move the window to the full up position.
1
Front Side Door Check Link Bolt
Tighten: 25 N.m (18 lb ft)
2
Front Side Door Check Link Nut (Qty: 2)
Tighten: 25 N.m (18 lb ft)
3
Front Side Door Check Link Assembly
Tip: Remove the check link from the inside of the door.
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
FUEL TANK FILLER PIPE HOUSING REPLACEMENT
Fig. 20: View Of Fuel Tank Filler Pipe Housing
Courtesy of GENERAL MOTORS CORP.
Fuel Tank Filler Pipe Housing Replacement
Preliminary Procedures
1. Remove the interior trim panel. Refer to Rear Side Door Trim Panel
Replacement .
2. Remove the water deflector. Refer to Rear Side Door Water Deflector
Replacement .
3. Move the window to the full up position.
1
Rear Side Door Check Link Bolt
Tighten: 25 N.m (18 lb ft)
2
Rear Side Door Check Link Nut (Qty: 2)
Tighten: 25 N.m (18 lb ft)
3
Rear Side Door Check Link Assembly
Tip: Remove the check link from the inside of the door.
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
1
Cap, Fuel
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
HOOD STRUT REPLACEMENT
Fig. 21: View Of Hood Strut
Courtesy of GENERAL MOTORS CORP.
Hood Strut Replacement
2
Pocket, Fuel Filler
Tip: Disengage locking tabs by pulling on the outer edge of the pocket while
working around the circumference.
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
NOTE:
Refer to Fastener Notice .
Hood Strut Rod
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
SEAL REPLACEMENT - FENDER TO HOOD
Fig. 22: Replacing Fender To Hood Seal
Courtesy of GENERAL MOTORS CORP.
Seal Replacement - Fender to Hood
HOOD FRONT SEAL REPLACEMENT
1
Tip: Use a small flat bladed screwdriver to disengage the locking tabs at
each end of the strut.
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
1
Seal, Hood Side
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bolted Exterior Body Panels and Closures - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст