Hummer H3. Manual — part 290
Courtesy of GENERAL MOTORS CORP.
1. Install the drive belt (1) over all the pulleys, except for the water pump pulley (2).
2. Install the 3/8 inch breaker bar into the drive belt tensioner (7).
3. Rotate the tensioner (7) clockwise.
4. Install the drive belt (1) over the top of the water pump pulley (2).
5. Slowly release the tension on the drive belt tensioner (7).
6. Inspect for proper installation of the drive belt (1) on the pulleys.
DRIVE BELT TENSIONER REPLACEMENT
Removal Procedure
IMPORTANT: Ensure the drive belt is properly aligned and seated into the
grooves of the drive pulleys.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 37: View Of Drive Belt Tensioner
Courtesy of GENERAL MOTORS CORP.
1. Remove the drive belt. Refer to Drive Belt Replacement (Without A/C) or Drive Belt
Replacement (With A/C).
2. Using a wrench, loosen and remove the drive belt tensioner bolt.
3. Remove the drive belt tensioner.
Installation Procedure
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 38: View Of Drive Belt Tensioner
Courtesy of GENERAL MOTORS CORP.
1. Position the drive belt tensioner. Ensure the alignment tab is in the proper location.
2. Install the drive belt tensioner bolt.
Tighten: Tighten the bolt to 50 N.m (37 lb ft).
3. Inspect the drive belt. Replace the drive belt if necessary.
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
4. Install the drive belt Drive Belt Replacement (Without A/C) or Drive Belt
Replacement (With A/C).
DRIVE BELT IDLER PULLEY REPLACEMENT
Removal Procedure
Fig. 39: View Of Drive Belt Idler Pulley & Bolts
Courtesy of GENERAL MOTORS CORP.
1. Remove the drive belt. Refer to Drive Belt Replacement (Without A/C) or Drive Belt
Replacement (With A/C).
2. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст