Hummer H3. Manual — part 1578
2007 STEERING
Power Steering - H3
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
POWER STEERING PUMP SPECIFICATIONS
Power Steering Pump Specifications
DIAGNOSTIC INFORMATION AND PROCEDURES
DIAGNOSTIC STARTING POINT - POWER STEERING SYSTEM
Begin the system diagnosis by reviewing the system Description and Operation. Refer to Power
Steering System Description and Operation. Reviewing the Description and Operation
information will help you determine the correct symptom diagnostic procedure when a
malfunction exists. Reviewing the Description and Operation information will also help you
Application
Specification
Metric
English
Power Steering Gear Inlet and Outlet Hose
Retaining Plate Bolt
12 N.m
106 lb in
Power Steering Gear Inlet and Outlet Hose Bracket
Bolt
9 N.m
80 lb in
Power Steering Gear Inlet Hose Fitting
25 N.m
18 lb ft
Power Steering Pump Bolt
25 N.m
18 lb ft
Power Steering Pump Bracket Bolt
50 N.m
37 lb ft
Rack and Pinion Inner Tie Rod
88 N.m
65 lb ft
Rack and Pinion Outer Tie Rod End Nut
71 N.m
52 lb ft
Steering Gear Bolt
130 N.m
96 lb ft
Steering Gear Bracket Bolt
100 N.m
74 lb ft
Engine Code Engine Size
High Flow
(Liters per
Minute)
High Flow
(Gallons per
Minute)
Pressure
Relief (kPa)
Pressure
Relief (PSI)
L52
3.5L
9.4/10.9
2.50/2.90
9308/9997
1350/1450
2007 Hummer H3
2007 STEERING Power Steering - H3
2007 Hummer H3
2007 STEERING Power Steering - H3
determine if the condition described by the customer is normal operation. Refer to Symptoms -
Power Steering System in order to identify the correct procedure for diagnosing the system and
where the procedure is located.
SYMPTOMS - POWER STEERING SYSTEM
Visual/Physical Inspection
Inspect for aftermarket devices which could affect the operation of the power steering
system.
Inspect the easily accessible or visible system components for obvious damage or conditions
which could cause the symptom.
Inspect for leaking power steering components. If necessary, refer to Power Steering Fluid
Leaks.
Verify the power steering reservoir for the proper operating specification. Refer to
Checking and Adding Power Steering Fluid.
Inspect the power steering fluid for the following indications of contamination:
Milky fluid - water
Brown fluid - burnt
Debris in fluid - plastic or dirt
If necessary, flush the power steering system. Refer to Power Steering System Flushing.
Symptoms List
Refer to a symptom diagnostic procedure from the following list in order to diagnose the
symptom:
Power Steering Fluid Leaks
Rattle, Clunk or Shudder Noise from the Power Steering System
Whine or Growl Noise from the Power Steering System
Steering Effort Hard in One or Both Directions
Steering Effort Too Easy in One or Both Directions
POWER STEERING SYSTEM TEST
IMPORTANT: Review the system description and operation in order to
familiarize yourself with the system functions. Refer to Power
Steering System Description and Operation.
2007 Hummer H3
2007 STEERING Power Steering - H3
Fig. 1: Testing Rack and Pinion System Pressures
Courtesy of GENERAL MOTORS CORP.
Callouts For Fig. 1
Test Description
The numbers below refer to the step numbers on the diagnostic table.
5: This step tests the system for restrictions.
7: This step tests the following components for the following conditions:
The pump for internal leaks
Callout
Component Name
1
Power Steering Return Hose
2
Power Steering Pressure Hose
2007 Hummer H3
2007 STEERING Power Steering - H3
The power steering pipes for kinks
8: This step tests the ability of the pump to regulate flow at maximum pressure.
10: This step tests the ability of the pump to regulate flow under normal operating
conditions.
12: This step tests the internal components of the pump and the gear.
Power Steering System Test
Step
Action
Value(s)
Yes
No
DEFINITION: The Power Steering System Test Procedure will perform the following
functions:
Test the operation of the hydraulic power steering system.
Test the operation of the power steering pump and power steering gear.
Identify restrictions in the system.
1
Inspect the power steering fluid for
the following indications of
contamination:
Milky fluid - water
Brown fluid - burnt
Debris in fluid - plastic or dirt
Is the fluid free of contamination?
-
Go to Step 3 Go to Step 2
2
Flush the power steering system.
Refer to Power Steering System
Flushing.
Did you complete the procedure?
-
Go to Step 3
-
3
Attempt to duplicate the condition.Is
the condition present?
IMPORTANT:
In order to accurately diagnose the
system, the malfunction must be
present during the test procedure.
-
Go to Step 4 System OK
1. Turn the ignition switch to the
OFF position.
2007 Hummer H3
2007 STEERING Power Steering - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст