Hummer H3. Manual — part 1306
Callouts For Fig. 3
HYDRAULIC BRAKE CONNECTOR END VIEWS
Brake Fluid Level Switch
Fig. 4: Brake Fluid Level Switch Connector End Views
Courtesy of GENERAL MOTORS CORP.
Brake Fluid Level Switch Connector Parts Information
Callout
Component Name
1
Inflatable Restraint Vehicle Rollover Sensor (ASF)
2
Yaw Rate/Lateral and Longitudinal Accelerometer Sensor (JL4)
3
Brake Fluid Reservoir
4
Electronic Brake Control Module (EBCM) C2
5
Electronic Brake Control Module (EBCM)
6
Electronic Brake Control Module (EBCM) C1
7
Brake Fluid Level Switch
Connector Part Information
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
Brake Fluid Level Switch Connector Terminal Identification
Park Brake Switch
Fig. 5: Park Brake Switch Connector End Views
OEM: 4F5288
Service: 15201888
Description: 2-Way F 2.3 II Series, Sealed (GY)
Terminal Part Information
Terminal/Tray: 8100-0460/6
Core/Insulation Crimp: E/1
Release Tool/Test Probe: 15315247/J-35616-2A (GY)
Pin
Wire Color
Circuit No.
Function
1
BK
850
Ground
2
PK
849
Brake Fluid Level Sensor Signal
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
Courtesy of GENERAL MOTORS CORP.
Park Brake Switch Connector Parts Information
Park Brake Switch Connector Terminal Identification
DIAGNOSTIC INFORMATION AND PROCEDURES
DIAGNOSTIC CODE INDEX
DIAGNOSTIC CODE INDEX
DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKES
Begin the system diagnosis by reviewing the system Description and Operation. Reviewing the
Description and Operation information will help you determine the correct symptom diagnostic
procedure when a malfunction exists. Reviewing the Description and Operation information will
also help you determine if the condition described by the customer is normal operation. Refer to
Symptoms - Hydraulic Brakes in order to identify the correct procedure for diagnosing the
system and where the procedure is located.
DTC C0130
Diagnostic Instructions
Connector Part Information
OEM: 8911256
Service: 12102561
Description: 1-Way F 56 Series (WH)
Terminal Part Information
Terminal/Tray: 12124515/1
Core/Insulation Crimp: See Terminal Kit
Release Tool/Test Probe: 12094430/J-35616-42 (RD)
Pin
Wire Color
Circuit No.
Function
A
L-BU
1134
Park Brake Switch Signal
DTC
Description
DTC C0130
** DESCRIPTION NOT COLLECTED **
DTC C0267
**DESCRIPTION NOT COLLECTED **
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic approach.
Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC C0130
Low Brake Fluid Circuit Open
Diagnostic Fault Information
DTC C0130
Circuit/System Description
The electronic brake control module (EBCM) monitors the brake fluid level switch via the brake
fluid level sensor signal circuit. With the switch closed, the signal circuit is pulled to ground
indicating low fluid level. When low fluid level is seen, the EBCM will send a serial data
message to the IPC illuminating the red brake warning indicator. The body control module
(BCM) monitors the park brake switch via the park brake switch signal circuit. With the park
brake applied, the switch is closed and the signal circuit is grounded. The BCM will then send a
serial data message to the IPC requesting the red brake warning indicator be illuminated.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM detects an open in the low brake fluid circuit.
Action Taken When the DTC Sets
The EBCM disables the traction control system (TCS)/dynamic rear proportion
(DRP)/vehicle stability enhancement system (VSES) for the duration of the ignition cycle.
The Brake Warning indicator turns ON.
Circuit
Short to
Ground
Open/High
Resistance
Short to
Voltage
Signal
Performance
Low Brake Fluid Signal Circuit
C0267
C0130
-
-
Ground
-
C0130
C0130
-
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст