Hummer H3. Manual — part 323
sprocket.
2. Install the intake camshaft sprocket onto the intake camshaft.
3. Install a NEW intake camshaft sprocket bolt.
Tighten: Tighten the bolt a first pass to 20 N.m (15 lb ft). Using the J 45059 rotate the bolt
a final pass an additional 100 degrees. See Special Tools.
IMPORTANT:
To aid in aligning the sprocket to the camshaft, use a 25
mm (1 in) wrench on the hex of the camshaft to rotate
Ensure the alignment pin is properly engaged with the
camshaft
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 153: View Of J 44217 & EN-44217-45 At Timing Chains
Courtesy of GENERAL MOTORS CORP.
4. Remove the J-44217-45 (1). See Special Tools.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 154: View Of J 44221 Installed On Camshafts
Courtesy of GENERAL MOTORS CORP.
5. Remove the J 44221 from the camshafts. See Special Tools.
6. Install the intake CMP sensor. Refer to Camshaft Position Sensor Replacement -
Intake .
7. Install the camshaft cover. Refer to Camshaft Cover Replacement.
TIMING CHAIN AND SPROCKET REPLACEMENT
Tools Required
J 44221 Camshaft Holding Tool. See Special Tools.
J 45059 Angle Meter. See Special Tools.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Removal Procedure
1. Remove the #1 cylinder spark plug. Refer to Spark Plug Replacement .
2. Remove the camshaft cover. Refer to Camshaft Cover Replacement.
3. Remove the exhaust camshaft position (CMP) sensor. Refer to Camshaft Position Sensor
Replacement - Exhaust .
4. Remove the intake CMP sensor. Refer to Camshaft Position Sensor Replacement -
Intake .
5. Remove the engine front cover. Refer to Engine Front Cover Replacement.
6. Rotate the crankshaft in the engine rotational direction clockwise, until the #1 piston is at
top dead center (TDC) on the compression stroke.
Fig. 155: View Of J 44221 Installed On Camshafts
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст