Hummer H3. Manual — part 900
Fig. 23: Checking Inboard Stroke Position
Courtesy of GENERAL MOTORS CORP.
14. Check the inboard stroke position.
2007 Hummer H3
2007 Driveline/Axle Wheel Drive Shafts - H3
Fig. 24: View Of Drive Axle Large Seal Retaining Clamp
Courtesy of GENERAL MOTORS CORP.
15. Install a new large retaining clamp. Crimp the large retaining clamp using the pliers J 35566
(1). See Special Tools.
Tighten: Tighten the large retaining clamp to 176 N.m (130 lb ft).
16. Fully stroke the D/O joint several times to disperse the grease.
17. Install the wheel drive shaft. Refer to Wheel Drive Shaft Replacement.
2007 Hummer H3
2007 Driveline/Axle Wheel Drive Shafts - H3
WHEEL DRIVE SHAFT OUTER JOINT AND BOOT REPLACEMENT
Tools Required
J 35910 Drive Axle Seal Clamp Plier. See Special Tools.
J 8059 Snap Ring Pliers. See Special Tools.
Removal Procedure
Fig. 25: View Of Driveshaft Retaining Clamps
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: When replacing the outer seal you MUST replace the inner
2007 Hummer H3
2007 Driveline/Axle Wheel Drive Shafts - H3
1. Remove the inner seal. Refer to Wheel Drive Shaft Inner Joint and Boot Replacement.
2. Use a hand grinder to cut through the large retaining clamp (3) located at the C/V joint (4).
Discard the large retaining clamp.
3. Use a hand grinder to cut through the small retaining clamp (1) on the small end of the outer
seal (2).
Discard the small retaining clamp.
Fig. 26: View Of Outer Seal & C/V Joint
Courtesy of GENERAL MOTORS CORP.
seal.
IMPORTANT: Do not damage the outer race while using the hand grinder.
2007 Hummer H3
2007 Driveline/Axle Wheel Drive Shafts - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст