Hummer H3. Manual — part 914
Courtesy of GENERAL MOTORS CORP.
Rear Bumper Impact Bar Replacement
REAR BUMPER STEP PAD REPLACEMENT
Callout
Component Name
Preliminary Procedure:
Remove the rear bumper step pad. Refer to Rear Bumper Step Pad Replacement.
1
Rear Bumper Impact Bar Bolts (Qty: 2)
Tighten: 1 N.m (1 lb ft)
NOTE:
Refer to Fastener Notice .
2
Front Tow Hook Bracket Bolts (Qty: 2)
Tighten: 100 N.m (74 lb ft)
3
Rear Bumper Impact Bar Bolts (Qty: 4)
Tighten: 1 N.m (1 lb ft)
4
Rear Bumper Impact Bar
Tip: Disconnect any electrical connectors before attempting to remove the
rear bumper impact bar.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bumpers and Fascias - H3
Fig. 7: Step Pad Replacement - Rear Bumper
Courtesy of GENERAL MOTORS CORP.
Rear Bumper Step Pad Replacement
Callout
Component Name
1
Rear Bumper Pad
Tip: Reach under the rear bumper assembly to access the retaining tabs and
squeeze them while lifting on the pad to release it from the bumper
assembly.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Bumpers and Fascias - H3
2007 TRANSMISSION
Clutch - H3
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
SEALERS AND LUBRICANTS
Sealers and Lubricants
DIAGNOSTIC INFORMATION AND PROCEDURES
DIAGNOSTIC STARTING POINT - CLUTCH
Reviewing the Clutch System Description and Operation will help you determine the correct
diagnostic procedure when a malfunction exists. Reviewing the description and operation
information will also help you determine if the condition described by the customer is normal
operation. Refer to Symptoms - Clutch in order to identify the correct procedure for diagnosing
the system and where the procedure is located.
SYMPTOMS - CLUTCH
Strategy Based Diagnostics
Application
Specification
Metric
English
Clutch Actuator Cylinder Bolt
8 N.m
71 lb in
Clutch Pedal Assembly Nut
20 N.m
15 lb ft
Clutch Pressure Plate Bolt
First Pass
20 N.m
15 lb ft
Final Pass
45 degrees
Application
Type of Material
GM Part Number
United
States
Canada
Clutch Hydraulic Fluid
DOT 3 Hydraulic
Fluid
12345347
992667
2007 Hummer H3
2007 TRANSMISSION Clutch - H3
2007 Hummer H3
2007 TRANSMISSION Clutch - H3
Review the system operations in order to familiarize yourself with the system functions. Refer to
Clutch System Description and Operation.
Visual/Physical Inspection
Inspect the easily accessible or visible system components for obvious damage or conditions
which could cause the symptom.
Inspect the clutch master cylinder for the correct fluid level.
Inspect the hydraulic clutch lines for dents, kinks or other obvious damage that may affect
the clutch system operations.
Inspect the clutch system for contamination of dirt, oil or other substances that may affect
the clutch system operations.
Intermittent
Test the vehicle under the same conditions that the customer reported, in order to verify the
system is operating properly.
Symptom List
Refer to a symptom diagnostic procedure from the following list in order to diagnose the
symptom:
Clutch Drag Hard Shifting
Clutch Slipping
Clutch Grabbing
Clutch Rattle
Clutch Noisy
Clutch Pedal Spongy Low Pedal Effort
Clutch Pedal Hard to Push
Clutch Vibration
CLUTCH DRAG HARD SHIFTING
Clutch Drag Hard Shifting
Cause
Action
DEFINITION: The clutch does not disengage completely to allow smooth shift operations.
It may cause gear clashing while the vehicle is not moving, at idle and shifting out of neutral
or hard shifting in and out of gears while driving the vehicle.
2007 Hummer H3
2007 TRANSMISSION Clutch - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст