Hummer H3. Manual — part 1020
Correction
None required.
Service Hints
Loose bearings on the drive pinion or in the differential case may cause patterns that vary. If the
contact pattern varies, inspect the following preload settings:
Total assembly
Differential case
Pinion
If these settings are correct, inspect for damage or incorrectly assembled parts.
Drive Side Heel - Coast Side Toe Contact Pattern
Fig. 126: Identifying Drive Side Heel - Coast Side Toe Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The backlash is incorrect. The ring gear is too far away from the pinion.
Correction
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Decrease the backlash. Move the ring gear closer to the pinion by adjusting the side bearing shim
thickness or the adjuster sleeve(s). Refer to Backlash Adjustment.
Drive Side Toe - Coast Side Heel Contact Pattern
Fig. 127: Identifying Drive Side Toe - Coast Side Heel Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The backlash is incorrect. The ring gear is too close to the drive pinion.
Correction
Increase the backlash. Move the ring gear away from the pinion by adjusting the side bearing
shim thickness or the adjuster sleeve(s). Refer to Backlash Adjustment.
Drive Side Heel - Coast Side Heel Contact Pattern
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Fig. 128: Identifying Drive Side Heel - Coast Side Heel Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The backlash is incorrect. The ring gear is too far away from the pinion.
Correction
Decrease the backlash. Move the ring gear closer to the pinion by adjusting the side bearing shim
thickness or the adjuster sleeve(s). Refer to Backlash Adjustment.
Drive Side Toe - Coast Side Toe Contact Pattern
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Fig. 129: Identifying Drive Side Toe - Coast Side Toe Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The backlash is incorrect. The ring gear is too close to the drive pinion.
Correction
Increase the backlash. Move the ring gear away from the pinion by adjusting the side bearing
shim thickness or the adjuster sleeve(s). Refer to Backlash Adjustment.
High Flank Contact Pattern
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст