Hummer H3. Manual — part 530
Fig. 150: View Of Lifter Guides & Lifters
Courtesy of GENERAL MOTORS CORP.
1. Install the valve lifter. Refer to Valve Lifter Installation.
2008 Hummer H3
2008 ENGINE Engine Mechanical - 5.3L - H3
Fig. 151: View Of Cylinder Head (Left)
Courtesy of GENERAL MOTORS CORP.
2. Install the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side or
to Cylinder Head Replacement - Right Side.
CRANKSHAFT BALANCER REPLACEMENT
Special Tools
J 41478 Crankshaft Front Oil Seal Installer. See Special Tools.
J 41665 Crankshaft Balancer and Sprocket Installer. See Special Tools.
J 41816-A Crankshaft Balancer Remover. See Special Tools.
J 41816-2 Crankshaft End Protector
2008 Hummer H3
2008 ENGINE Engine Mechanical - 5.3L - H3
J 42386-A Flywheel Holding Tool. See Special Tools.
J 45059 Angle Meter
Removal Procedure
Fig. 152: Air Conditioning Drive Belt
Courtesy of GENERAL MOTORS CORP.
1. Remove the air conditioning (A/C) drive belt. Refer to Air Conditioning Compressor
Belt Replacement (LH8).
2. Remove the cooling fan and shroud. Refer to Fan Shroud Replacement (LLR) .
3. Remove the starter motor. Refer to Starter Motor Replacement (LH8) .
2008 Hummer H3
2008 ENGINE Engine Mechanical - 5.3L - H3
4. Install the J 42386-A (1) and bolts. See Special Tools. Use one M10-1.5 x 120 mm and
one M10-1.5 x 45 mm bolt for proper tool operation.
Tighten: Tighten the J 42386-A bolts to 50 N. See Special Tools.m (37 lb ft).
NOTE:
Refer to Fastener Notice .
IMPORTANT: Ensure that the teeth of the J 42386-A mesh with the teeth of
the engine flywheel. See Special Tools.
2008 Hummer H3
2008 ENGINE Engine Mechanical - 5.3L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст