Hummer H3. Manual — part 854
8. Install the accumulator bolt (115), model dependent.
Tighten: Tighten the accumulator bolt to 11 N.m (8.11 lb ft).
Fig. 446: Installing 1-2 Accumulator Housing Bolts
Courtesy of GENERAL MOTORS CORP.
9. Install the 1-2 accumulator housing assembly (57 or 116).
10. Install the 1-2 accumulator housing bolts (58, 59 or 117, 118).
NOTE:
Refer to FASTENER NOTICE .
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Tighten:
Tighten the bolts 58 and 59 to 11 N.m (8 lb ft).
Tighten the bolts 117 and 118 to 8-14 N.m (6-10 lb ft).
CONTROL VALVE BODY INSTALLATION
Tools Required
J 25025-5 Dial Indicator Mounting Post-M6 x 1. See Special Tools.00
J 36850 Transjel Lubricant
Installation Procedure
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 447: Identifying Secondary Fluid Pump Connector
Courtesy of GENERAL MOTORS CORP.
1. Inspect the wiring harness and solenoid assembly for the following conditions:
Damage
Cracked connectors
Exposed wires
Loose electrical terminals
Damaged wiring loom and conduit
Worn, missing or cut pass-through connector O-ring seal.
2. Install the transmission wiring harness pass-through connector into the transmission case.
Ensure connector tabs lock into place.
3. Move the harness to one side in order to install the valve body.
IMPORTANT: Secondary fluid pump connector (1) is used for M33 models
only, connector (2) is used on ISS models.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 448: Identifying Checkball Installation Positions
Courtesy of GENERAL MOTORS CORP.
4. Install the ball check valves (2-6, 8, 12) in the valve body and retain ball check valves with
IMPORTANT: Valve bodies are model dependent.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст