Hummer H3. Manual — part 1231
TRANSMISSION SUPPORT CROSSMEMBER REPLACEMENT
Fig. 7: View Of Transmission Support Crossmember
Courtesy of GENERAL MOTORS CORP.
Transmission Support Crossmember Replacement
1
Tighten: 100 N.m (74 lb ft)
NOTE:
Refer to Fastener Notice .
2
Crossmember Nut (Qty: 4)
Tighten: 70 N.m (52 lb ft) plus 200 degrees
3
Crossmember Bolt (Qty: 4)
4
Crossmember
Callout
Component Name
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Frame and Underbody - H3
FRAME CUSHION OR INSULATOR REPLACEMENT
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Preliminary Procedures
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the transfer case shield. Refer to Transfer Case Shield Replacement .
3. Support the transmission with a transmission jack.
NOTE:
Refer to Fastener Notice .
1
Transmission Mount Nut (Qty: 2)
Tighten: 57 N.m (42 lb ft)
2
Transmission Support Bolt (Qty: 4)
Tighten: 100 N.m (74 lb ft)
3
Transmission Support Nut (Qty: 4)
Tighten: 50 N.m (37 lb ft)
4
Transmission Support Bolt (Qty: 4)
5
Transmission Support
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Frame and Underbody - H3
Fig. 8: Locating Frame Cushion Or Insulators
Courtesy of GENERAL MOTORS CORP.
Frame Cushion or Insulator Replacement
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening
Specifications.Preliminary Procedure: Raise the vehicle. Refer to Lifting and Jacking
the Vehicle .
NOTE:
Refer to Fastener Notice .
1
Bolt, Frame cushion/Insulator (Qty: 12)
Tip: It is only necessary to remove the cushion/insulator bolt of the
cushion/insulator being replaced. Though it may be necessary to loosen the
cushion/insulator bolts to either side of the cushion/insulator being replaced
in order to gain enough clearance to remove the cushion/insulator(s) being
replaced.
Tighten: 115 N.m (85 lb ft)
2
Cushion/Insulator, Frame (Qty: 12)
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Frame and Underbody - H3
WHEELHOUSE PANEL REPLACEMENT (FRONT)
Fig. 9: Replacing Wheelhouse Panel
Courtesy of GENERAL MOTORS CORP.
Wheelhouse Panel Replacement (Front)
WHEELHOUSE PANEL REPLACEMENT (REAR)
3
Cushion/Insulator, Frame (Qty: 12)
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Preliminary Procedures
1. Lift and support vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front wheel. Refer to Tire and Wheel Removal and Installation .
1
Retainer, Front Wheelhouse Panel (Qty: 10)
2
Panel, Front Wheelhouse
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Frame and Underbody - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст