Hummer H3. Manual — part 755
2. Connect the transmission vent hose retainer (1, 6) to the following:
The heater pipe bracket (2)
The transmission range selector cable bracket (5)
3. Lower the vehicle.
2-4 SERVO
Tools Required
J 29714-A Servo Cover Depressor. See Special Tools.
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front propeller shaft (4WD only). Refer to Front Propeller Shaft
Replacement .
3. Clean away all dirt and debris from the 2-4 servo cover area.
4. Remove a single transmission oil pan bolt.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 89: Compressing The Servo Cover Using J 29714-A
Courtesy of GENERAL MOTORS CORP.
5. Install the J 29714-A in place of the transmission oil pan bolt. See Special Tools.
6. Tighten the bolt in order to compress the servo cover.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 90: Removing The Servo Cover Ring
Courtesy of GENERAL MOTORS CORP.
7. Remove the servo cover retaining ring.
8. Remove the J 29714-A . See Special Tools.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 91: Removing The Servo Cover And O-Ring Seal
Courtesy of GENERAL MOTORS CORP.
9. Remove the servo cover and the O-ring seal. If the cover is hung up on the seal, use a pick
(2) to pull and stretch the seal (1) out of the groove. Cut and remove the O-ring seal before
removing the cover.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст