Hummer H3. Manual — part 622
SCHEMATIC AND ROUTING DIAGRAMS
5
Electronic Brake and Traction Control Module Bolt
6
Electronic Brake and Traction Control Module Locator
7
Brake Fluid Level Indicator Wiring Harness Bracket
8
Power Brake Booster Pump Fluid Accumulator
9
Power Brake Booster Pump Fluid Accumulator (O-Ring) Seal
10
Power Brake Booster Pump Fluid Accumulator Fitting Spring
11
Power Brake Booster Pump Fluid Accumulator Fitting
12
Power Brake Booster Outlet Front Pipe
13
Power Brake Booster Pump Inlet Hose Clamp
14
Power Brake Booster Inlet Hose
15
Power Brake Booster Pump Harness Strap Bolt
16
Electronic Brake Control Wiring Plug
17
Power Brake Boost Pump Bracket ASM Bolt
18
Power Brake Booster Pump Damper Retainer
19
Power Brake Boost Pump Bracket
20
Power Brake Booster Pump Locator Pin
21
Power Brake Booster Pump Damper
22
Power Brake Booster Pump Damper Retainer
23
Power Brake Booster Pump Harness Strap
24
Power Brake Booster Pump ASM Motor
25
Electronic Brake and Traction Control Module ASM Gasket
26
Electronic Brake and Traction Control (w/Brake Pressure Modulator
Valve) ASM Module
27
Brake Master Cylinder Spacer
28
Brake Pedal Push Rod Boot
29
Brake Pedal Push Rod Clevis
30
Brake Pedal Push Rod Clevis Nut
31
Brake Master Cylinder Spacer
32
Brake Master Cylinder Spacer Gasket
33
Brake Master Cylinder
34
Brake Master Cylinder Reservoir Bolt
35
Brake Master Cylinder Reservoir ASM Cap
36
Brake Fluid Level Indicator Wiring Harness Bracket Bolt
2007 Hummer H3
2007 BRAKES Antilock Brake System - H3
ANTILOCK BRAKE SYSTEM SCHEMATIC ICONS
Antilock Brake System Schematic Icons
ANTILOCK BRAKE SYSTEM SCHEMATICS
Icon
Icon Definition
IMPORTANT:
Twisted-pair wires provide an effective shield that helps
protect sensitive electronic components from electrical
interference. If the wires were covered with shielding,
install new shielding.
In order to prevent electrical interference from degrading
the performance of the connected components, you must
maintain the proper specification when making any
repairs to the twisted-pair wires shown :
The wires must be twisted a minimum of 9 turns
per 31 cm (12 in) as measured anywhere along the
length of the wires.
The outside diameter of the twisted wires must not
exceed 6.0 mm (0.25 in).
2007 Hummer H3
2007 BRAKES Antilock Brake System - H3
Fig. 2: Power, Ground and Electronic Brake Control Module (EBCM) Schematic
Courtesy of GENERAL MOTORS CORP.
2007 Hummer H3
2007 BRAKES Antilock Brake System - H3
Fig. 3: Power, Ground and Electronic Brake Control Module (EBCM) Schematic - RHD
Courtesy of GENERAL MOTORS CORP.
2007 Hummer H3
2007 BRAKES Antilock Brake System - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст