Hummer H3. Manual — part 1369
Fig. 13: Sunshade Replacement
Courtesy of GENERAL MOTORS CORP.
Sunshade Replacement
SUNSHADE ANCHOR REPLACEMENT
Callout
Component Name
1
Sunshade Screws (Qty: 2)
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
2
Sunshade Assembly
Tip: Disconnect the electrical connector, if equipped.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - H3
Fig. 14: Sunshade Anchor Replacement
Courtesy of GENERAL MOTORS CORP.
Sunshade Anchor Replacement
WINDSHIELD PILLAR GARNISH MOLDING REPLACEMENT
Callout
Component Name
1
Sun Shade Bolt
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
2
Sun Shade Assembly Support
Tip: Disconnect the electrical connector, if equipped.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - H3
Fig. 15: Windshield Pillar Garnish Molding Replacement
Courtesy of GENERAL MOTORS CORP.
Windshield Pillar Garnish Molding Replacement
Callout
Component Name
Preliminary Procedures:
Disable SIR system. Refer to SIR Disabling and Enabling .
1
Windshield Side Garnish Bolt Hole Finish Plug
2
Windshield Side Garnish Screw
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - H3
BODY SIDE REAR UPPER GARNISH MOLDING REPLACEMENT
Fig. 16: Body Side Rear Upper Garnish Molding Replacement
Courtesy of GENERAL MOTORS CORP.
Body Side Rear Upper Garnish Molding Replacement
CENTER PILLAR UPPER TRIM PANEL REPLACEMENT
Tighten: 9 N.m (80 lb in)
3
Windshield Side Garnish Molding Assembly
Tip: Disconnect the electrical connector.
Callout
Component Name
1
Upper Body Side Garnish Bolt Hole Finish Plug
2
Upper Body Side Garnish Screw
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
3
Upper Body Side Garnish Molding Assembly
4
Upper Body Side Garnish Retainer (Qty: 9)
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст