Hummer H3. Manual — part 226
Fig. 525: View Of Cylinder Head Bolt Hole Required Tools
Courtesy of GENERAL MOTORS CORP.
The cylinder head bolt hole required tools consist of the following:
Drill (1) J 42385-402
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Tap (2) J 42385-403
Installation driver (3) J 42385-404
Alignment pin (4) J 42385-303
Bushing (5) J 42385-302
Bolts (6) J 42385-421
Fixture plate (7) J 42385-401
When installed to the proper depth, the flange of the insert will be seated against the counterbore
of the drilled/tapped hole.
CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
IMPORTANT:
Remove the fixture plate prior to installing the insert with the
installer tool.
The use of a cutting type fluid GM P/N 1052864 (Canadian P/N
992881), WD 40® or equivalent is recommended when
performing the drilling, counterboring and tapping
procedures.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Fig. 526: View Of Bushing, Fixture Plate, Bolts & Bolt Hole
Courtesy of GENERAL MOTORS CORP.
1. Position the fixture plate (3) with the bushing (1) installed over the cylinder head bolt hole
to be repaired (4).
2. Loosely install the fixture plate bolts (2) into the remaining cylinder head bolt holes.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Fig. 527: View Of Alignment Pin & Fixture Retaining Bolts
Courtesy of GENERAL MOTORS CORP.
3. Position the alignment pin (1) through the bushing and into the cylinder head bolt hole.
4. With the alignment pin in the desired cylinder head bolt hole, tighten the fixture retaining
bolts (2).
5. Remove the alignment pin (1) from the cylinder head bolt hole.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст