Hummer H3. Manual — part 1598
Fig. 11: View Of Upper Absorber Bolts
Courtesy of GENERAL MOTORS CORP.
1. Install the absorber.
2. Install the upper absorber bolts.
Tighten: Tighten the bolts to 35 N.m (26 lb ft).
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
Fig. 12: View Of Lower Shock Absorber Mounting Bolt & Nut
Courtesy of GENERAL MOTORS CORP.
3. Install the lower absorber bolt and nut.
Tighten: Tighten the nut to 95 N.m (70 lb ft).
4. Remove the rear axle support.
5. Lower the vehicle.
SHOCK ABSORBER DISPOSAL
CAUTION: Gas charged shock absorbers contain high pressure gas. Do
not remove the snap ring from inside the top of the tube. If the
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
snap ring is removed, the contents of the shock absorber will
come out with extreme force which may result in personal
injury.
CAUTION: To prevent personal injury, wear safety glasses when
centerpunching and drilling the shock absorber. Use care not
to puncture the shock absorber tube with the centerpunch.
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст