Hummer H3. Manual — part 1682
Fig. 96: Locating Front Case Half Vent
Courtesy of GENERAL MOTORS CORP.
4. If the vent is removed, apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to
the threads on the vent.
5. Install the vent.
Tighten: Tighten the vent to 6 N.m (53 lb in).
2007 Hummer H3
2007 TRANSMISSION Transfer Case - BW 4493/4494 - H3
Fig. 97: Identifying Ring Gear At Front Case Half
Courtesy of GENERAL MOTORS CORP.
6. Install the ring gear in the front case half.
2007 Hummer H3
2007 TRANSMISSION Transfer Case - BW 4493/4494 - H3
Fig. 98: Identifying Ring Gear Retaining Ring
Courtesy of GENERAL MOTORS CORP.
7. Install a NEW ring gear retaining ring.
2007 Hummer H3
2007 TRANSMISSION Transfer Case - BW 4493/4494 - H3
Fig. 99: Input Shaft Bearing
Courtesy of GENERAL MOTORS CORP.
8. Install the input shaft bearing in the front case half.
Use a hammer and a brass drift only on the outer bearing race.
Ensure the bearing is kept square to the bore while installing.
IMPORTANT: Lubricate all of the bearings and bearing journals with
transfer case fluid during installation.
2007 Hummer H3
2007 TRANSMISSION Transfer Case - BW 4493/4494 - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст