Hummer H3. Manual — part 834
OIL PUMP ROTOR AND SLIDE MEASUREMENT
Fig. 374: Measuring Oil Pump Rotor & Slide
Courtesy of GENERAL MOTORS CORP.
Refer to Oil Pump Rotor and Slide Measurement .
Measure the oil pump rotor (212) thickness.
Measure the oil pump slide (203) thickness.
OIL PUMP BODY BUSHING REPLACEMENT
Tools Required
IMPORTANT: Measure the rotor and slide thickness for surface wear. The
rotor and slide measurements must both fall into the same
thickness range. If the rotor and slide measurements do not
fall into the same thickness range or are outside of all the
ranges, the oil pump must be replaced as an assembly.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
J 41778-1 Pump Body Bushing Installer/Remover. See Special Tools.
J 41778-2 Pump Body Bushing Position Stop. See Special Tools.
Procedure
Fig. 375: Inspecting Oil Pump Body
Courtesy of GENERAL MOTORS CORP.
1. Inspect the oil pump body for the following:
Worn or damaged bushings
Foreign material or debris
Porosity
Scored or irregular mating faces
Cross channel leaks
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 376: View Of Front Fluid Seal Retainer & Oil Seal Assembly
Courtesy of GENERAL MOTORS CORP.
2. Remove the front fluid seal retainer (244).
3. Remove the oil seal assembly (243).
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 377: Identifying Pump Body Bushing
Courtesy of GENERAL MOTORS CORP.
4. Using the J 41778-1 (1) with an arbor press, remove the pump body bushing (242). See
Special Tools.
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст