Hummer H3. Manual — part 155
15. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Fig. 261: View Of Transmission Mounting Bolts & Engine Dowels
Courtesy of GENERAL MOTORS CORP.
16. Tighten the 2 transmission mounting bolts (2) previously installed.
Tighten: Tighten the transmission mounting bolts to 50 N.m (37 lb ft).
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Fig. 262: View Of Transmission Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
17. Install the remaining transmission mounting bolts.
Tighten: Tighten the transmission mounting bolts to 50 N.m (37 lb ft).
IMPORTANT:
Ensure the studded mounting bolts (2) are located in the
correct position.
The heater pipe (1) must be secured with the 2 upper
mounting bolts.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
18. Align the torque converter to flexplate/flywheel orientation marks made during the removal
procedure (automatic only).
19. Repeat the following steps for all 3 torque converter bolts (automatic only):
1. Rotate the harmonic balancer center bolt clockwise ONLY, in order to access the
torque converter bolt holes in the flexplate/flywheel through the service slot.
2. To aid in alignment of the torque converter to the flexplate/flywheel. Install all 3
torque converter bolts before fully tightening using one of the following:
Tighten: Tighten the torque converter bolts to 60 N.m (44 lb ft).
18 mm crowfoot wrench
Short T50 TORX bit
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Fig. 263: View Of Inspection Plug
Courtesy of GENERAL MOTORS CORP.
20. Install the inspection plug (3) to the transmission (1) (automatic only).
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст