Hummer H3. Manual — part 302
Fig. 78: View Of Valve Stem Seals
Courtesy of GENERAL MOTORS CORP.
15. Use the J 38820 in order to grip the seal. See Special Tools. Remove the seal by exerting a
twisting, pulling motion.
Discard the old valve stem seal.
Installation Procedure
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 79: View Of Valve Stem Seals
Courtesy of GENERAL MOTORS CORP.
1. Lubricate the valve stem and inner diameter of the new seal with clean engine oil.
2. Using a twisting, pushing motion install the NEW valve stem seal using the J 38820 . See
Special Tools.
IMPORTANT: Install a seal protector over the valve stem prior to installing
the valve stem seal.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 80: View Of Valve Springs & Retainers
Courtesy of GENERAL MOTORS CORP.
3. Install the valve spring and valve spring retainer.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 81: View Of J 44228 Base Plate
Courtesy of GENERAL MOTORS CORP.
4. Swing the arm over the valve spring retainer and tighten the swivel nut of the J-44228-A
down only enough to allow access for installation of the valve locks.
5. Position the valve locks to the valve stem retainer groove using the J 43059 .
6. Remove the swivel nut and arm of the J-44228-A
7. Install the arm and swivel nut of the J-44228-A over the stud of any other valves being
serviced for this cylinder and repeat removal steps 11 through 16 and installation steps 1
through 7.
8. Relieve the air pressure to the cylinder being serviced.
9. Remove the J 39313 from the spark plug hole. See Special Tools.
10. Remove the base plate of the J-44228-A .
11. Repeat removal steps 7 through 16 and installation steps 1 through 10 on any other cylinders
being serviced.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст