Hummer H3. Manual — part 990
J 45859 Axle Remover. See Special Tools.
Removal Procedure
Fig. 30: View Of Pinion Shaft Locking Bolt
Courtesy of GENERAL MOTORS CORP.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation .
3. Remove the brake caliper. Refer to Rear Brake Caliper Replacement .
4. Remove the rear cover and the gasket. Refer to Rear Axle Housing Cover and Gasket
Replacement.
5. Remove the pinion shaft locking bolt.
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Fig. 31: View Of Pinion Shaft
Courtesy of GENERAL MOTORS CORP.
6. On axles without a locking differential, remove the pinion shaft.
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Fig. 32: Axle Shaft Housing & Components
Courtesy of GENERAL MOTORS CORP.
7. Push the flange of the axle shaft (1) toward the differential.
8. Remove the C-lock (4) from the button end of the axle shaft (1).
9. Remove the axle shaft (1) from the housing (5).
IMPORTANT: When removing the axle shaft, do not rotate the shaft.
Rotating the shaft will misalign the gears. Misaligning the
gears will make the assembly difficult.
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Fig. 33: Removing Axle Shaft Using J 45859 & J 2619-01
Courtesy of GENERAL MOTORS CORP.
10. If the axle is difficult to remove, use the J 45859 (1) and the J 2619-01 (2) to remove the
axle shaft from the housing. See Special Tools.
Installation Procedure
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст