Hummer H3. Manual — part 339
18. Clean and inspect the oil pan. Refer to Oil Pan Cleaning and Inspection.
19. Clean and inspect the engine block sealing surface.
Installation Procedure
Fig. 209: View Of Oil Pan Sealant Application
Courtesy of GENERAL MOTORS CORP.
1. Apply a 5.5 mm (0.22 in) bead of sealer to the oil pan in the areas marked (1). Refer to
Sealers, Adhesives and Lubricants.
2. Apply a 3 mm (0.12 in) bead of sealer to the oil pan in the area marked (2). Refer to
Sealers, Adhesives and Lubricants.
IMPORTANT: The oil pan must be installed within 10 minutes from when
the sealer was applied.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 210: View Oil Pan & Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
3. Position the oil pan to the engine block.
4. Ensure the oil pan is positioned fully rearward against the transmission mounting surface.
IMPORTANT: Use care not to allow the sealer to contact the oil pump pipe
and screen assembly.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
5. Install the oil pan bolts.
6. Tighten the oil pan bolts.
Tighten:
Tighten the (side) bolts to 25 N.m (18 lb ft).
Tighten the (end) bolts to 10 N.m (89 lb in).
7. Connect the engine wiring harness retainers to the oil pan.
8. Position the power steering gear upward to the frame assembly.
9. Install the power steering gear. Refer to Steering Gear Replacement .
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 211: View Of Transmission Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
10. Install the 4 lower transmission mounting bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
11. Install the nuts securing the fuel hose/pipe bracket to the transmission.
Tighten: Tighten the nuts to 20 N.m (15 lb ft).
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст