Hummer H3. Manual — part 925
Courtesy of GENERAL MOTORS CORP.
1. Install the clutch actuator cylinder release bearing (2) over the clutch actuator cylinder dust
cover (1).
2. Install the transmission. Refer to Transmission Replacement .
CLUTCH ACTUATOR CYLINDER REPLACEMENT
Removal Procedure
1. Remove the transmission. Refer to Transmission Replacement .
IMPORTANT: Do not allow the release bearing to become damaged,
replace if dropped or damaged.
2007 Hummer H3
2007 TRANSMISSION Clutch - H3
Fig. 27: View Of Clutch Actuator Cylinder
Courtesy of GENERAL MOTORS CORP.
2. Remove the 2 clutch actuator cylinder bolts (3).
3. Remove the clutch actuator cylinder (1) from the input shaft bearing retainer (2).
Installation Procedure
2007 Hummer H3
2007 TRANSMISSION Clutch - H3
Fig. 28: View Of Clutch Actuator Cylinder
Courtesy of GENERAL MOTORS CORP.
1. Position the clutch actuator cylinder (1) to the input shaft bearing retainer (2).
2. Install the 2 clutch actuator cylinder bolts (3).
Tighten: Tighten the clutch actuator cylinder bolts to 8 N.m (71 lb in).
3. Install the transmission. Refer to Transmission Replacement .
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 TRANSMISSION Clutch - H3
DESCRIPTION AND OPERATION
CLUTCH SYSTEM DESCRIPTION AND OPERATION
The Hummer H3 vehicle uses the 3.7L (LLR) clutch.
The 3.7L (LLR) clutch system is described as the following:
Size - 265 mm (10.4 in)
Clutch pressure plate - Diaphragm spring plate, non-self adjusting
Clutch disc - Dampener spring style
Hydraulic system
Clutch System Components
2007 Hummer H3
2007 TRANSMISSION Clutch - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст