Hummer H3. Manual — part 1277
Fig. 44: Air Inlet Assembly Replacement (Right Hand Drive)
Courtesy of GENERAL MOTORS CORP.
Air Inlet Assembly Replacement (Right Hand Drive)
Callout
Component Name
Preliminary Procedures
1. Remove the HVAC module assembly. Refer to HVAC Module Assembly
Replacement (Left Hand Drive) or HVAC Module Assembly Replacement
(Right Hand Drive).
2. Disconnect the recirculation actuator electrical connector.
1
Recirculation Housing Screw (Qty: 4)
Tighten: 1.5 N.m (14 lb in)
NOTE:
Refer to Fastener Notice .
2
Recirculation Housing
3
Recirculation Actuator Screw (Qty: 3)
2007 Hummer H3
2007 HVAC Heating, Ventilation and Air Conditioning - H3
BLOWER MOTOR RESISTOR ASSEMBLY REPLACEMENT (LEFT HAND DRIVE)
Fig. 45: Blower Motor Resistor Assembly Replacement (Left Hand Drive)
Courtesy of GENERAL MOTORS CORP.
Blower Motor Resistor Assembly Replacement (Left Hand Drive)
Tighten: 1.5 N.m (13 lb in)
4
Recirculation Actuator
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening
Specifications.Preliminary Procedure: Disconnect the blower motor resister electrical
connector.
NOTE:
Refer to Fastener Notice .
1
Screw, Blower Motor Resistor
Tighten: 1.5 N.m (13 lb in)
2
Resistor, Blower Motor
2007 Hummer H3
2007 HVAC Heating, Ventilation and Air Conditioning - H3
BLOWER MOTOR RESISTOR ASSEMBLY REPLACEMENT (RIGHT HAND DRIVE)
Fig. 46: Blower Motor Resistor Assembly Replacement (Right Hand Drive)
Courtesy of GENERAL MOTORS CORP.
Blower Motor Resistor Assembly Replacement (Right Hand Drive)
BLOWER MOTOR REPLACEMENT (LEFT HAND DRIVE)
Callout
Component Name
Preliminary Procedure:
Disconnect the blower motor resister electrical connector.
1
Blower Motor Resistor Screw (Qty: 2)
Tighten: 1.5 N.m (13 lb in)
NOTE:
Refer to Fastener Notice .
2
Blower Motor Resistor
2007 Hummer H3
2007 HVAC Heating, Ventilation and Air Conditioning - H3
Fig. 47: Blower Motor Replacement (Left Hand Drive)
Courtesy of GENERAL MOTORS CORP.
Blower Motor Replacement (Left Hand Drive)
Callout
Component Name
Preliminary Procedures
1. Remove the cowl side trim panel. Refer to Cowl Side Trim Panel Replacement .
2. Remove I/P compartment door. Refer to Instrument Panel Compartment Door
Replacement .
3. Remove I/P outer trim cover. Refer to Instrument Panel Outer Trim Cover
Replacement - Right Side (Left Hand Drive) or Instrument Panel Outer Trim
Cover Replacement - Right Side (Right Hand Drive) .
4. Remove right side courtesy lamp.
5. Remove relay.
6. Tip:
Reposition right corner of I/P to gain clearance to blower motor for removal.
Blower Motor Resistor Screw (Qty: 2)
2007 Hummer H3
2007 HVAC Heating, Ventilation and Air Conditioning - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст