Hummer H3. Manual — part 1345
J-44894-A
Brake Bleeder Adapter
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
2007 ACCESSORIES & EQUIPMENT
Displays and Gages - H3
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
FUEL LEVEL SPECIFICATIONS
The information in this table is intended for use with the J 33431-C Signal Generator and
Instrument Panel Tester. The fuel level sensor values represent the test values to be used on the
Signal Generator to drive the fuel gage display to the indicated positions. Vehicles that require
more than one fuel level sensor calculate gage position from many possible resistance
combinations of fuel levels between the two tanks. Therefore, the values in the table may not
correlate directly to readings taken from the vehicle primary or secondary sending units.
The values in this table are approximate values based on information obtained from properly
operating vehicles. Actual results may vary slightly.
Fuel Level Specifications
SCHEMATIC AND ROUTING DIAGRAMS
Application
Specification
Metric
English
Instrument Panel Accessory Switch Assembly
Screws
2 N.m
18 lb in
Instrument Panel Cluster Assembly Screws
2 N.m
18 lb in
Fuel Gage Display
Resistance
Fuel Level
Fuel Remaining
19.8 Gallon Tank
E
40-70 ohms
0-10%
0-8.5 L (0-2.3 gal)
1/4
110 ohms
28%
23.4 L (6.2 gal)
1/2
143 ohms
51%
38.3 L (10.1 gal)
3/4
181 ohms
74%
53.2 L (14.1 gal)
F
215-250 ohms
90-100%
68.1-75.7 L (18-20 gal)
Low Fuel Indicator
On
63 ohms
7%
9.3 L (2.4 gal)
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
INSTRUMENT CLUSTER SCHEMATICS
Fig. 1: Power, Ground, MIL and Security Schematic
Courtesy of GENERAL MOTORS CORP.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
Fig. 2: Gages Schematic
Courtesy of GENERAL MOTORS CORP.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст