Hummer H3. Manual — part 1310
BRAKING ACTION UNEVEN - PULLS TO ONE SIDE
Test Description
The numbers below refer to the step numbers on the diagnostic table.
4: Suspension components that are not operating properly may cause a disturbance to the
vehicle during application of the brake system.
5: Steering components that are not operating properly may cause a disturbance to the
vehicle during application of the brake system.
Braking Action Uneven - Pulls to One Side
Step
Action
Yes
No
DEFINITION: Vehicle pulls to one side only when braking.
1
Were you sent here from the Hydraulic
Brake Symptom table?
Go to Step 2
Go to
Diagnostic
Starting Point -
Hydraulic
Brakes
2
1. Inspect the hydraulic brake system
for the following conditions.
Kinked, pinched or damaged
brake pipe or flexible brake
hose
Sticking or improperly
operating caliper piston
Brake fluid leak
2. Adjust, repair or replace
components as necessary. Refer to
Hydraulic Brake System
Diagnosis.
Did you find and correct a condition?
Go to Step 6
Go to Step 3
1. Inspect the disc brake system for the
following conditions.
Contaminated linings
Glazed linings
Distorted, cracked or damaged
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
3
linings on one side
Loose, damaged or missing
caliper hardware and/or lining
hardware
Incorrect linings on one side
Hard spots, heat checks,
blueing discoloration of rotor
friction surfaces; possibly due
to brake drag
Glazed rotor friction surfaces
Bent or damaged caliper or
mounting component
2. Adjust, repair or replace
components as necessary. Refer to
Disc Brake System Diagnosis.
Did you find and correct a condition?
Go to Step 6
Go to Step 4
4
1. Inspect the suspension system for the
following conditions.
Incorrect tire pressures
Loose suspension component
connections
Excessively worn or damaged
suspension components
2. Adjust, repair or replace
components as necessary. Refer to
Diagnostic Starting Point -
Suspension General Diagnosis .
Did you find and correct a condition?
Go to Step 6
Go to Step 5
5
1. Inspect the steering system for the
following conditions.
Loose steering component
connections
Excessively worn or damaged
steering components
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
BRAKING ACTION UNEVEN - FRONT TO REAR
Test Descriptions
The number below refers to the step number on the diagnostic table.
4: Suspension components that are not operating properly may cause a disturbance to the
vehicle during application of the brake system.
Braking Action Uneven - Front to Rear
2. Adjust, repair or replace
components as necessary. Refer to
Diagnostic Starting Point - Power
Steering System .
Did you find and correct a condition?
Go to Step 6
Go to
Diagnostic
Starting Point -
Hydraulic
Brakes
6
1. Install or connect components that
were removed or disconnected
during diagnosis.
2. Road test the vehicle in order to
confirm proper operation. Refer to
Brake System Vehicle Road Test.
Is the condition still present?
Go to Step 2
System OK
Step
Action
Yes
No
DEFINITION: Braking action or stopping force sensitive or grabbing and/or more
pronounced at the front or at the rear axle. Sensitive or grabbing brakes: Excessive brake
jump-in force relative to brake pedal input.
1
Were you sent here from the Hydraulic
Brake Symptom table?
Go to Step 2
Go to
Diagnostic
Starting Point -
Hydraulic
Brakes
1. Inspect the hydraulic brake system for
the following conditions:
Improper operation of caliper
pistons
Kinked, pinched or damaged
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
2
brake pipe or flexible brake hose
Brake fluid leak
Improperly functioning
proportion valve, if equipped
Improper operation of dynamic
rear proportion (DRP) system, if
equipped
2. Adjust, repair or replace components
as necessary. Refer to Hydraulic
Brake System Diagnosis.
Did you find and correct a condition?
Go to Step 6
Go to Step 3
3
1. Inspect the disc brake system for the
following conditions:
Contaminated linings
Glazed linings
Distorted, cracked or damaged
linings
Excessively worn linings
Aftermarket linings
Damaged or excessively worn
caliper hardware and/or lining
hardware
Hard spots, heat checks, blueing
discoloration of rotor friction
surfaces
Glazed rotor friction surfaces
2. Adjust, repair or replace components
as necessary. Refer to Disc Brake
System Diagnosis.
Did you find and correct a condition?
Go to Step 6
Go to Step 4
1. Inspect the suspension system for the
following conditions:
Loose suspension component
connections
2007 Hummer H3
2007 BRAKES Hydraulic Brakes - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст