Hummer H3. Manual — part 847
Fig. 422: Identifying Isolator Valve & Regulator Apply Valve
Courtesy of GENERAL MOTORS CORP.
27. Remove the bore plug retainer (395) and the bore plug (381).
28. Remove the regulator apply valve (380) and the regulator apply spring (397) and the
isolator valve (398).
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 423: View Of 4-3 Sequence Valve & 3-4 Relay Valve
Courtesy of GENERAL MOTORS CORP.
29. Remove the bore plug retainer (395) and the bore plug (381).
30. Remove the 3-4 relay valve (384) and the 4-3 sequence valve (383) and the 4-3 sequence
valve spring (382).
CONTROL VALVE BODY ASSEMBLE
Inspection Procedure
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Fig. 424: Inspecting Control Valve Body For Channel Witness Marks
Courtesy of GENERAL MOTORS CORP.
1. Inspect the valve body to spacer plate gasket for valve body channel witness marks. The
witness marks should be complete. Incomplete witness marks may be caused by an uneven
case surface. Incomplete witness marks may also be caused by cross-channel leaks.
2. Inspect the valve body casting for the following conditions:
Porosity
Cracks
Damaged machined surfaces
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Chips or debris
Cleaning Procedure
1. Clean all the valves, springs, bushings and the control valve body in clean solvent.
2. Dry all the parts using compressed air.
Installation Procedure
Fig. 425: Identifying Isolator Valve & Regulator Apply Valve
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to Valve Springs Can Be Tightly Compressed
2007 Hummer H3
2007 TRANSMISSION Automatic Transmission - 4L60-E/4L65-E/4L70-E - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст