Hummer H3. Manual — part 973
Fig. 105: Identifying High Flank Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The pinion depth is incorrect. The pinion gear is too far away from the ring gear.
Correction
Increase the pinion depth. Move the pinion gear closer to the ring gear by increasing the pinion
shim thickness. Refer to Pinion Depth Adjustment.
Low Flank Contact Pattern
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Fig. 106: Identifying Low Flank Contact Pattern
Courtesy of GENERAL MOTORS CORP.
Condition
The pinion depth is incorrect. The pinion gear is too close to the ring gear.
Correction
Decrease the pinion depth. Move the pinion gear away from the ring gear by decreasing the
pinion shim thickness. Refer to Pinion Depth Adjustment.
DESCRIPTION AND OPERATION
FRONT DRIVE AXLE DESCRIPTION AND OPERATION
The Front Drive Axle consist of the following components:
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Differential Carrier Housing
Differential Assembly
Intermediate Shaft
Intermediate Shaft Housing
Electric Motor Actuator
Shift Fork/Clutch Assembly
The front axle on four wheel drive model vehicles has a central disconnect feature. The axle uses
a conventional ring and pinion gear set in order to transmit the driving force of the engine to the
wheels. The open differential allows the wheels to turn at different rates of speed while the axle
continues to transmit the driving force. This prevents tire scuffing when going around corners and
premature wear on internal axle parts. The ring and pinion set and the differential are contained
within the carrier. The axle identification number on top of the differential carrier assembly or on
a label on the right half of differential carrier assembly. The drive axles are completely flexible
assemblies consisting of inner and outer constant velocity CV joints protected by thermoplastic
boots and connected by a wheel drive shaft.
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS
Special Tools
Illustration
Tool Number/Description
J 5590
Pinion Bearing Race Installer - Rear
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
J 7817
Outer Bearing Race Installer
J 8001
Dial Indicator Set
J 8092
Driver Handle
2007 Hummer H3
2007 Driveline/Axle Front Drive Axle - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст