Hummer H3. Manual — part 1359
Electrical Information Reference
Circuit Testing
Connector Repairs
Testing for Intermittent Conditions and Poor Connections
Wiring Repairs
Scan Tool Reference
Scan Tool Data List
Circuit/System Testing
1. Ignition OFF, raise the vehicles drive wheels.
2. Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter
matches the speedometer display.
If the Vehicle Speed Sensor parameter does not match the speedometer display,
replace the IPC.
3. Verify that the odometer is operating properly.
If the odometer is not operating properly, replace the IPC.
Repair Procedures
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for IPC replacement, setup and programming
TACHOMETER INACCURATE OR INOPERATIVE
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic approach.
Diagnostic Procedure Instructions provides an overview of each diagnostic category.
Circuit/System Description
The instrument panel cluster (IPC) displays the engine speed based on the information from the
powertrain control module (PCM). The PCM converts the data from the engine speed sensor to a
2 pulses/engine revolution signal. The PCM sends the engine speed information via class 2 serial
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
data circuit to the IPC in order to display the engine speed.
Reference Information
Schematic Reference
Instrument Cluster Schematics
Connector End View Reference
Displays and Gages Connector End Views
Electrical Information Reference
Circuit Testing
Connector Repairs
Testing for Intermittent Conditions and Poor Connections
Wiring Repairs
Scan Tool Reference
Scan Tool Data List
Circuit/System Testing
Ignition ON, perform the tachometer gage sweep test with the scan tool.
If the tachometer gage does not sweep from its low to high position, replace the IPC.
Repair Procedures
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for IPC replacement, setup and programming
REPAIR INSTRUCTIONS
AMBIENT AIR TEMPERATURE SENSOR REPLACEMENT
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
Fig. 9: Ambient Air Temperature Sensor Replacement
Courtesy of GENERAL MOTORS CORP.
Ambient Air Temperature Sensor Replacement
INSTRUMENT CLUSTER REPLACEMENT (LEFT HAND DRIVE)
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening
Specifications.Preliminary Procedures: Remove the front grille. Refer to Grille
Replacement .
NOTE:
Refer to Fastener Notice .
1
Screw, Sensor Ambient Air Temperature
Tighten: 10 N.m (89 lb in)
2
Sensor, Ambient Air Temperature
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
Fig. 10: Instrument Panel Cluster (IPC) Replacement
Courtesy of GENERAL MOTORS CORP.
Instrument Cluster Replacement (Left Hand Drive)
Callout
Component Name
Preliminary Procedure:
Remove the instrument panel cluster trim plate. Refer to Instrument Cluster Trim Panel
Replacement (Left Hand Drive) or Instrument Cluster Trim Panel Replacement
(Right Hand Drive) .
1
Instrument Panel Cluster Screw (Qty: 4)
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
2
Instrument Panel Cluster Assembly
Procedure
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Displays and Gages - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст