Hummer H3. Manual — part 1626
Fig. 41: Locking Shoes To Dowel Pins
Courtesy of GENERAL MOTORS CORP.
2. Using the tilt lever, position the lock shoes to the dowel pins (2).
3. Rotate the steering column tilt head housing (1) in order to align the holes for the steering
column pivot pins.
2007 Hummer H3
2007 STEERING Steering Wheel and Column - H3
Fig. 42: View Of Pivot Pins At Steering Column Assembly
Courtesy of GENERAL MOTORS CORP.
4. Install the new steering column pivot pins by performing the following steps:
1. Lubricate the steering column pivot pins (1) with, GM P/N 12346293 (Canadian P/N
992723).
2. Press the steering column pivot pins (1) until the they are firmly seated.
3. Stake the steering column pivot pins (1) at 3 locations each.
5. Install the tilt spring. Refer to Steering Column Tilt Spring Replacement.
6. Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case
Replacement .
7. Install the steering column. Refer to Steering Column Replacement.
STEERING SHAFT UPPER BEARING REPLACEMENT
Removal Procedure
1. Remove the steering column tilt head housing. Refer to Steering Column Tilt Head
Housing Replacement.
2007 Hummer H3
2007 STEERING Steering Wheel and Column - H3
2. Remove the steering shaft upper bearing from the steering column tilt head housing.
Installation Procedure
1. Install the steering shaft upper bearing into the steering column tilt head housing.
2. Install the steering column tilt head housing. Refer to Steering Column Tilt Head
Housing Replacement.
STEERING COLUMN REPLACEMENT
Tools Required
J 42640 Steering Column Anti-Rotation Pin
Removal Procedure
1. Disable the supplemental inflatable restraint (SIR) System. Refer to SIR Disabling and
Enabling .
CAUTION: Refer to SIR Caution .
NOTE:
Once the steering column is removed from the vehicle, the
column is extremely susceptible to damage. Dropping the
column assembly on the end could collapse the steering shaft
or loosen the plastic injections, which maintain column
rigidity. Leaning on the column assembly could cause the
jacket to bend or deform. Any of the above damage could
impair the columns collapsible design. Do NOT hammer on the
end of the shaft, because hammering could loosen the plastic
injections, which maintain column rigidity. If you need to
remove the steering wheel, refer to Steering Wheel
Replacement procedure in this section.
NOTE:
The front wheels of the vehicle must be maintained in the
straight ahead position and the steering column must be in the
LOCK position before disconnecting the steering column or
intermediate shaft. Failure to follow these procedures will
cause improper alignment of some components during
installation and result in damage to the SIR coil assembly.
2007 Hummer H3
2007 STEERING Steering Wheel and Column - H3
Fig. 43: Steering Wheel Lock Tool
Courtesy of GENERAL MOTORS CORP.
2. Lock the steering column through the access hole in the lower steering column trim cover
using anti-rotation pin J 42640 .
3. Remove the driver knee bolster bracket. Refer to Driver Knee Bolster Bracket
Replacement (Left Hand Drive) or Driver Knee Bolster Bracket Replacement (Right
Hand Drive) .
4. Remove the upper intermediate steering shaft bolt at the steering column. Refer to Upper
Intermediate Steering Shaft Replacement.
5. Disconnect any electrical connectors as needed.
2007 Hummer H3
2007 STEERING Steering Wheel and Column - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст