Hummer H3. Manual — part 1205
Fig. 39: View Of Radio & Screws
Courtesy of GENERAL MOTORS CORP.
5. Install the 4 screws that retain the radio to the I/P.
Tighten: Tighten the screws to 2 N.m (18 lb in).
6. Install the accessory trim plate. Refer to Instrument Panel Center Trim Panel
Replacement (Left Hand Drive) or Instrument Panel Center Trim Panel
Replacement (Right Hand Drive) .
7. Program the radio after replacement. Refer to Control Module References .
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ACCESSORIES AND EQUIPMENT Cellular, Entertainment and Navigation - H3
DIGITAL RADIO RECEIVER REPLACEMENT
Removal Procedure
1. Remove the instrument panel (I/P) compartment door. Refer to Instrument Panel
Compartment Door Replacement .
2. Remove the right I/P outer trim cover. Refer to Instrument Panel Outer Trim Cover
Replacement - Right Side (Left Hand Drive) or Instrument Panel Outer Trim Cover
Replacement - Right Side (Right Hand Drive) .
IMPORTANT: Do NOT swap digital radio receivers between vehicles.
Swapping digital receivers between vehicles will activate the
digital radio Theftlock® and "XM Theftlock®" will display.
2007 Hummer H3
2007 ACCESSORIES AND EQUIPMENT Cellular, Entertainment and Navigation - H3
Fig. 40: View Of Service Panel
Courtesy of GENERAL MOTORS CORP.
3. Unfold the service panel located above the I/P compartment door.
Fig. 41: View Of Digital Radio Receiver Retaining Screws
Courtesy of GENERAL MOTORS CORP.
4. Remove the screws retaining the digital radio receiver to the I/P structure.
2007 Hummer H3
2007 ACCESSORIES AND EQUIPMENT Cellular, Entertainment and Navigation - H3
Fig. 42: View Of Digital Radio Receiver
Courtesy of GENERAL MOTORS CORP.
5. Lower the receiver from the I/P.
IMPORTANT: Do not attempt to pry or slide the electrical connector
release lever (1).
2007 Hummer H3
2007 ACCESSORIES AND EQUIPMENT Cellular, Entertainment and Navigation - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст