Hummer H3. Manual — part 52
Fig. 34: Battery Cable Harness Clips
Courtesy of GENERAL MOTORS CORP.
8. Install the battery cable harness clips (1, 2) to the battery tray.
9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and
Connection.
BATTERY REPLACEMENT (LH8)
Removal Procedure
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Fig. 35: Engine Wiring Harness Electrical Connector & Battery Current Sensor
Courtesy of GENERAL MOTORS CORP.
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection
and Connection.
2. Open the protective cover to access the engine wiring harness/positive battery cable
terminal.
3. Loosen the engine wiring harness/positive battery cable nut (1).
4. Remove the engine wiring harness/positive battery cable from the battery.
5. Remove the engine wiring harness/positive battery cable clip (2) from the upper battery
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
box.
Fig. 36: Battery Vent Duct
Courtesy of GENERAL MOTORS CORP.
6. Disconnect the battery vent duct from the upper battery box (1).
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Fig. 37: Upper Battery Box Cover
Courtesy of GENERAL MOTORS CORP.
7. Press the locking tabs (1) inward in order to remove the upper battery box (2) from the
lower battery box.
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст