Hummer H3. Manual — part 347
CRANKSHAFT REAR OIL SEAL REPLACEMENT
Tools Required
J 8092 Driver Handle
J 44215 Rear Seal Installer. See Special Tools.
Removal Procedure
1. Remove the flywheel. Refer to Engine Flywheel Replacement (w/Automatic
Transmission).
Fig. 239: Identifying Crankshaft Rear Oil Seal
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Do not damage the crankshaft or seal bore.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
2. Using a suitable tool, pry the crankshaft rear oil seal out from the crankshaft rear oil seal
housing. Discard the seal.
Installation Procedure
1. Lightly lubricate the crankshaft rear oil seal lip with clean engine oil.
2. Position the plastic installation sleeve supplied with the NEW seal to the crankshaft.
Fig. 240: Installing Crankshaft Rear Oil Seal
Courtesy of GENERAL MOTORS CORP.
3. Using the J 44215 with the J 8092 and a hammer, install the crankshaft rear oil seal into the
crankshaft rear oil seal housing. See Special Tools.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
The spring side of the seal goes toward the engine.
Ensure the seal is installed square.
The seal will bottom out in the housing when fully installed.
4. Install the flywheel. Refer to Engine Flywheel Replacement (w/Automatic
Transmission).
ENGINE FLYWHEEL REPLACEMENT (W/AUTOMATIC TRANSMISSION)
Tools Required
J 45059 Angle Meter. See Special Tools.
Removal Procedure
1. Remove the transmission. Refer to Transmission Replacement .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 241: View Of Engine Flywheel
Courtesy of GENERAL MOTORS CORP.
2. Remove and discard the flywheel bolts.
3. Remove the flywheel.
4. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection
(Automatic Transmission) or Engine Flywheel Cleaning and Inspection (Manual
Transmission).
Installation Procedure
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст