Hummer H3. Manual — part 1141
Fig. 19: View Of Starter Wiring
Courtesy of GENERAL MOTORS CORP.
14. Remove the starter terminal nut (1) and remove the positive battery cable terminal (2) from
the starter.
2007 Hummer H3
2007 ENGINE Engine Electrical - H3
Fig. 20: Identifying Generator/Starter Wiring
Courtesy of GENERAL MOTORS CORP.
15. Remove the bolt (5) securing the negative battery cable ground terminal (4) to the engine
block.
16. Remove the battery cable clip (3) from the engine wiring harness bracket.
17. Remove the battery cables from the vehicle.
Installation Procedure
2007 Hummer H3
2007 ENGINE Engine Electrical - H3
Fig. 21: Identifying Generator/Starter Wiring
Courtesy of GENERAL MOTORS CORP.
1. Insert the battery cables to the vehicle.
2. Install the battery cable clip (3) to the engine wiring harness bracket.
3. Install the bolt (5) securing the negative battery cable ground terminal (4) to the engine
block.
Tighten: Tighten the bolt to 35 N.m (26 lb ft).
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ENGINE Engine Electrical - H3
Fig. 22: View Of Starter Wiring
Courtesy of GENERAL MOTORS CORP.
4. Install the positive battery cable terminal (2) to the starter and the starter terminal nut (1).
5. Install the left wheelhouse liner. Refer to Wheelhouse Panel Replacement (Front) or
Wheelhouse Panel Replacement (Rear) .
2007 Hummer H3
2007 ENGINE Engine Electrical - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст