Hummer H3. Manual — part 1549
If the test lamp does not illuminate, test the control circuit for a short to ground or an
open/high resistance. If the circuit tests normal, test or replace the outside rearview
mirror switch.
10. Ignition ON, with the outside rearview mirror switch in the DOWN position, verify a test
lamp illuminates between the control circuit terminal 2 and ground.
If the test lamp does not illuminate, test the control circuit for a short to ground or an
open/high resistance. If the circuit tests normal, test or replace the outside rearview
mirror switch.
11. Ignition ON, with the outside rearview mirror switch in the LEFT position, verify a test
lamp illuminates between the control circuit terminal 2 and ground.
If the test lamp does not illuminate, test the control circuit for a short to ground or an
open/high resistance. If the circuit tests normal, test or replace the outside rearview
mirror switch.
12. Ignition ON, with the outside rearview mirror switch in the RIGHT position, verify a test
lamp illuminates between the control circuit terminal 1 and ground.
If the test lamp does not illuminate, test the control circuit for a short to ground or an
open/high resistance. If the circuit tests normal, test or replace the outside rearview
mirror switch.
13. If all circuits test normal, test or replace the applicable outside rearview mirror motor.
Repair Procedures
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Power Mirror Switch Replacement
Mirror Replacement
Control Module References for BCM replacement, setup and programming
REPAIR INSTRUCTIONS
POWER MIRROR SWITCH REPLACEMENT
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Mirrors - H3
Fig. 13: Replacing Power Mirror Switch
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Mirrors - H3
Courtesy of GENERAL MOTORS CORP.
Power Mirror Switch Replacement
OUTSIDE REARVIEW MIRROR REPLACEMENT
Fig. 14: Replacing Outside Rearview Mirror
Courtesy of GENERAL MOTORS CORP.
Mirror Replacement
Callout
Component Name
1
Front Side Door Accessory Switch Mount Plate Assembly
2
Front Side Door Accessory Switch Mount Plate Clip (Qty: 2)
3
Power Mirror Switch Assembly
Callout
Component Name
NOTE:
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Mirrors - H3
OUTSIDE REARVIEW MIRROR GLASS REPLACEMENT
Fastener Tightening Specifications: Refer to Fastener Tightening
Specifications.Preliminary Procedure: Remove the interior trim panel. Refer to Front
Side Door Trim Panel Replacement .
Refer to Fastener Notice .
1
Bolt, Mirror Outside Rear View (Qty: 4)
Tip: Disconnect mirror electrical connector.
Tighten: 10 N.m (89 lb in)
2
Mirror Assembly, Outside Rear View
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Mirrors - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст