Hummer H3. Manual — part 593
Fig. 37: Replacing Inflatable Restraint Steering Wheel Module
Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Steering Wheel Module Replacement
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
Preliminary Procedures
1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling
and Enabling.
2. On back side of the steering wheel shroud are 2 openings, place the wheel so that one
opening is on top.
3. Using a blunt-ended tool, push the spring fastener inward through the access hole.
Repeat the step for the other opening.
CAUTION:
Refer to SIR Inflator Module Handling and Storage Caution .
CAUTION:
Refer to SIR Caution .
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
INFLATABLE RESTRAINT STEERING WHEEL MODULE COIL REPLACEMENT
Removal Procedure
1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and
Enabling.
2. Remove the steering wheel. Refer to Steering Wheel Replacement .
3. Remove the steering column trim covers. Refer to Steering Column Trim Covers
Replacement .
1
Module, Steering Wheel Inflatable Restraint
Tip:
1. Release the connector position assurance (CPA) retainer.
2. Disconnect the electrical connectors.
3. Fully deploy the module before disposal. If the module was replaced
under warranty, fully deploy and dispose of the module after the
required retention period. Refer to Inflator Module Handling and
Scrapping.
IMPORTANT: The inflatable restraint steering wheel module coil and the
multifunction turn signal switch are serviced as an assembly.
CAUTION: Refer to SIR Caution .
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 38: View Of Wire Harness Straps & Assembly
Courtesy of GENERAL MOTORS CORP.
4. Remove the wire harness straps from the wire harness assembly.
5. Disconnect any electrical connectors as needed.
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 39: View Of Multifunction Switch/SIR Coil Assembly
Courtesy of GENERAL MOTORS CORP.
6. Remove the inflatable restraint steering wheel module coil bolts.
7. Slide the inflatable restraint steering wheel module coil off of the steering column. Discard
the inflatable restraint steering wheel module coil, if replacing.
Installation Procedure
IMPORTANT: A new inflatable restraint steering wheel module coil will
come precentered with a centering tab attached. Do NOT
remove the centering tab until installation is complete.
Failure to follow procedure will cause a misalignment and re-
centering of the inflatable restraint steering wheel module
coil will be required.
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст